Network Appliance NS0-165 Dumps
Network Appliance NS0-165 Practice Test 58
Question 570
For this case—An ONTAP SVM contains the requested LUN but its VMware initiators discover no target because iSCSI service addresses were never configured.—which implementation and acceptance check are correctly paired?
Explanation
Correct Answer
The situation is that an ONTAP SVM contains the requested LUN but its VMware initiators discover no target because iSCSI service addresses were never configured. Enable supported iSCSI service on an SVM, provide reachable iSCSI data LIFs and map the correct LUN to authorized initiators. Validation: From a sanctioned test initiator, log in to approved targets and verify only the intended LUN identifier is discovered. The action and test belong together because creating a LUN is only part of SAN service provisioning; target discovery and LUN masking determine which hosts can access it.
Incorrect Answers
“design alua and host multipathing for resilient san access” evaluates a different intervention. The appropriate action is to enable supported iSCSI service on an SVM, provide reachable iSCSI data LIFs and map the correct LUN to authorized initiators. To confirm, from a sanctioned test initiator, log in to approved targets and verify only the intended LUN identifier is discovered.
That action-and-evidence pair concerns “plan fibre channel zoning and ONTAP target wwpn access”, not this decision. The appropriate action is to enable supported iSCSI service on an SVM, provide reachable iSCSI data LIFs and map the correct LUN to authorized initiators. To confirm, from a sanctioned test initiator, log in to approved targets and verify only the intended LUN identifier is discovered.
The proposed pair focuses on “use igroups and lun mapping for explicit host access” instead. The appropriate action is to enable supported iSCSI service on an SVM, provide reachable iSCSI data LIFs and map the correct LUN to authorized initiators. To confirm, from a sanctioned test initiator, log in to approved targets and verify only the intended LUN identifier is discovered.
Question 571
A virtualization cluster is connected to a Fibre Channel fabric but hosts cannot see the expected ONTAP target WWPNs. Which implementation or design choice most directly mitigates the stated issue?
Explanation
Correct Answer
Configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone. To verify, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
Incorrect Answers
This alternative focuses on “use igroups and lun mapping for explicit host access” instead of the required outcome. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
That choice concerns “design alua and host multipathing for resilient san access”, not the immediate requirement. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
“validate nvme over fabrics namespace and host compatibility” is related to another task, not the failure shown here. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Question 572
A virtualization cluster is connected to a Fibre Channel fabric but hosts cannot see the expected ONTAP target WWPNs. Which technical explanation most directly supports the right approach?
Explanation
Correct Answer
An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone. This supports the decision to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports.
Incorrect Answers
“validate nvme over fabrics namespace and host compatibility” explains a different mechanism. Here, an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
That statement concerns “troubleshoot iscsi discovery and authentication separately” rather than the cause in this case. Here, an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
The principle behind “use igroups and lun mapping for explicit host access” is not the one being tested. Here, an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Question 573
For this situation—A virtualization cluster is connected to a Fibre Channel fabric but hosts cannot see the expected ONTAP target WWPNs.—which check provides the strongest verification?
Explanation
Correct Answer
Inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery. It is the relevant test because an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Incorrect Answers
This evidence addresses “validate nvme over fabrics namespace and host compatibility” instead of confirming the repair. To check this result, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
“design alua and host multipathing for resilient san access” would verify a different part of the system. To check this result, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
That test concerns “configure iscsi target access with supported svm interfaces and initiators”, not the requested outcome. To check this result, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
Question 574
A virtualization cluster is connected to a Fibre Channel fabric but hosts cannot see the expected ONTAP target WWPNs. If the team does the following—"Zone every FC initiator into one unrestricted fabric group and assume LUN masking alone provides appropriate isolation."—what could go wrong?
Explanation
Correct Answer
Hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks. The shortcut is unsafe because an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Incorrect Answers
The alternative risk relates to “The host continues experiencing I/O stalls while a larger disk allocation wastes resources”, not the stated mistake. Here, hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks.
That consequence concerns “Concurrent block writes can corrupt the filesystem or expose sensitive application storage”, which is a different failure. Here, hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks.
“The host cannot enumerate the device even though the controller and network links are healthy” does not describe the result of this shortcut. Here, hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks.
Question 575
A virtualization cluster is connected to a Fibre Channel fabric but hosts cannot see the expected ONTAP target WWPNs. Which action and validation evidence belong together?
Explanation
Correct Answer
Configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. Validation: Inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery. The action and test belong together because an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Incorrect Answers
The linked action and check for “validate nvme over fabrics namespace and host compatibility” would not resolve this case. The appropriate action is to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. To confirm, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
That action-and-evidence pair concerns “diagnose fc path visibility using fabric and switch evidence”, not this decision. The appropriate action is to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. To confirm, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
“design alua and host multipathing for resilient san access” evaluates a different intervention. The appropriate action is to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. To confirm, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
Question 576
During a NetApp ONTAP maintenance review, A SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. What is the most appropriate next decision?
Explanation
Correct Answer
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. Configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone. To verify, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
Incorrect Answers
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. That choice concerns “design alua and host multipathing for resilient san access”, not the immediate requirement. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
The proposed action addresses “configure iscsi target access with supported svm interfaces and initiators” rather than the problem described. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. “validate nvme over fabrics namespace and host compatibility” is related to another task, not the failure shown here. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Question 577
A SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. Why does the recommended approach address this particular concern?
Explanation
Correct Answer
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. An FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone. This supports the decision to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports.
Incorrect Answers
The principle behind “design alua and host multipathing for resilient san access” is not the one being tested. Here, an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
“diagnose san lun missing from igroup or map” describes another technical distinction. Here, an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. “validate nvme over fabrics namespace and host compatibility” explains a different mechanism. Here, an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Question 578
A SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. Which evidence best validates the proposed outcome?
Explanation
Correct Answer
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. Inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery. It is the relevant test because an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Incorrect Answers
This evidence addresses “configure iscsi target access with supported svm interfaces and initiators” instead of confirming the repair. To check this result, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
That test concerns “use igroups and lun mapping for explicit host access”, not the requested outcome. To check this result, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
The proposed check is relevant to “design alua and host multipathing for resilient san access”, but not sufficient here. To check this result, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
Question 579
Consider this situation: A SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. A team member suggests: "Zone every FC initiator into one unrestricted fabric group and assume LUN masking alone provides appropriate isolation." What is the main risk?
Explanation
Correct Answer
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. Hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks. The shortcut is unsafe because an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Incorrect Answers
“Concurrent block writes can corrupt the filesystem or expose sensitive application storage” can arise elsewhere, but it is not the most direct risk here. Here, hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks.
That consequence concerns “The application may see no disk or an unauthorized initiator could be allowed through careless mapping”, which is a different failure. Here, hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks.
The alternative risk relates to “A single switch or adapter fault may disconnect the host from block storage despite healthy ONTAP…”, not the stated mistake. Here, hosts can be exposed to unintended targets and difficult-to-debug path conflicts or security risks.
Question 580
A storage operations lead considers: A SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. Which response and evidence should be linked?
Explanation
Correct Answer
The situation is that a SAN architect must create controlled zones between database HBAs and the corresponding NetApp target ports. Configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. Validation: Inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery. The action and test belong together because an FC path depends on host HBA, fabric zoning, target state and LUN mapping, not on volume existence alone.
Incorrect Answers
That action-and-evidence pair concerns “use igroups and lun mapping for explicit host access”, not this decision. The appropriate action is to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. To confirm, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
The proposed pair focuses on “create ONTAP s3 object access with svm service and bucket policies” instead. The appropriate action is to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. To confirm, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
“configure iscsi target access with supported svm interfaces and initiators” evaluates a different intervention. The appropriate action is to configure a supported FC target and switch zoning design that permits intended initiators to see the appropriate ONTAP target ports. To confirm, inspect approved WWPN zones and confirm the host sees target ports and expected multipath devices after discovery.
NetApp Certified Data Administrator, ONTAP (NS0-165) Practice Tests
- Network Appliance NS0-165 Practice Test 56 - 10 Questions (Last Reviewed 24-Sep-2026)
- Network Appliance NS0-165 Practice Test 57 - 10 Questions (Last Reviewed 19-Nov-2026)
- Network Appliance NS0-165 Practice Test 58 - 10 Questions (Last Reviewed 18-Nov-2026)
- Network Appliance NS0-165 Practice Test 59 - 10 Questions (Last Reviewed 17-Nov-2026)
- Network Appliance NS0-165 Practice Test 60 - 10 Questions (Last Reviewed 16-Nov-2026)