Network Appliance NS0-165 Dumps
Network Appliance NS0-165 Practice Test 55
Question 540
For this case—A support engineer needs to separate DNS failure from NFS service failure on an otherwise reachable ONTAP interface.—which implementation and acceptance check are correctly paired?
Explanation
Correct Answer
The situation is that a support engineer needs to separate DNS failure from NFS service failure on an otherwise reachable ONTAP interface. Compare client DNS lookup, SVM name-service reachability and direct IP connectivity before blaming a storage protocol daemon. Validation: Resolve a test SMB or NFS hostname and then connect by a verified IP, recording which operation fails. The action and test belong together because a failed hostname lookup can mimic an unavailable file service even when the storage LIF and transport are functioning.
Incorrect Answers
The situation is that a support engineer needs to separate DNS failure from NFS service failure on an otherwise reachable ONTAP interface. That action-and-evidence pair concerns “troubleshoot failed lif or port reachability from actual evidence”, not this decision. The appropriate action is to compare client DNS lookup, SVM name-service reachability and direct IP connectivity before blaming a storage protocol daemon. To confirm, resolve a test SMB or NFS hostname and then connect by a verified IP, recording which operation fails.
The proposed pair focuses on “use broadcast domains and ipspaces for appropriate network separation” instead. The appropriate action is to compare client DNS lookup, SVM name-service reachability and direct IP connectivity before blaming a storage protocol daemon. To confirm, resolve a test SMB or NFS hostname and then connect by a verified IP, recording which operation fails.
“diagnose mtu mismatches on high-speed ONTAP paths” evaluates a different intervention. The appropriate action is to compare client DNS lookup, SVM name-service reachability and direct IP connectivity before blaming a storage protocol daemon. To confirm, resolve a test SMB or NFS hostname and then connect by a verified IP, recording which operation fails.
Question 541
A high-throughput NFS host reports unstable large transfers after an engineer enables jumbo frames on just one switch. Which implementation or design choice most directly mitigates the stated issue?
Explanation
Correct Answer
Confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size. To verify, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
Incorrect Answers
“troubleshoot failed lif or port reachability from actual evidence” is related to another task, not the failure shown here. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
This alternative focuses on “test DNS dependencies separately from raw IP connectivity” instead of the required outcome. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
That choice concerns “use packet errors and switch counters to isolate poor network performance”, not the immediate requirement. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Question 542
A high-throughput NFS host reports unstable large transfers after an engineer enables jumbo frames on just one switch. Which technical explanation most directly supports the right approach?
Explanation
Correct Answer
A link can pass small probes while larger frames are dropped because one device does not support the configured packet size. This supports the decision to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used.
Incorrect Answers
The principle behind “troubleshoot failed lif or port reachability from actual evidence” is not the one being tested. Here, a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
“understand cluster and intercluster data network roles” explains a different mechanism. Here, a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
That statement concerns “use packet errors and switch counters to isolate poor network performance” rather than the cause in this case. Here, a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Question 543
For this situation—A high-throughput NFS host reports unstable large transfers after an engineer enables jumbo frames on just one switch.—which check provides the strongest verification?
Explanation
Correct Answer
Run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path. It is the relevant test because a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Incorrect Answers
“use packet errors and switch counters to isolate poor network performance” would verify a different part of the system. To check this result, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
That test concerns “test DNS dependencies separately from raw IP connectivity”, not the requested outcome. To check this result, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
This evidence addresses “choose lif service policies and failover groups for supported protocols” instead of confirming the repair. To check this result, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
Question 544
A high-throughput NFS host reports unstable large transfers after an engineer enables jumbo frames on just one switch. If the team does the following—"Enable jumbo frames only on storage ports and assume all switches and clients automatically use the same MTU."—what could go wrong?
Explanation
Correct Answer
Large I/O requests can stall or retransmit despite apparently healthy small-packet network pings. The shortcut is unsafe because a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Incorrect Answers
That consequence concerns “Users continue seeing name-based mount failures while data remains intact and accessible by correct IP”, which is a different failure. Here, large I/O requests can stall or retransmit despite apparently healthy small-packet network pings.
“The LIF can appear administratively up while frames never reach its client or gateway” does not describe the result of this shortcut. Here, large I/O requests can stall or retransmit despite apparently healthy small-packet network pings.
The alternative risk relates to “Remote users remain disconnected while access policies become overly permissive”, not the stated mistake. Here, large I/O requests can stall or retransmit despite apparently healthy small-packet network pings.
Question 545
A high-throughput NFS host reports unstable large transfers after an engineer enables jumbo frames on just one switch. Which action and validation evidence belong together?
Explanation
Correct Answer
Confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. Validation: Run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path. The action and test belong together because a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Incorrect Answers
“troubleshoot failed lif or port reachability from actual evidence” evaluates a different intervention. The appropriate action is to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. To confirm, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
The linked action and check for “trace gateway and routing errors for remote storage clients” would not resolve this case. The appropriate action is to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. To confirm, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
That action-and-evidence pair concerns “use packet errors and switch counters to isolate poor network performance”, not this decision. The appropriate action is to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. To confirm, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
Question 546
An ONTAP storage administrator considers: A storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. What is the most appropriate next decision?
Explanation
Correct Answer
The situation is that a storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. Confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size. To verify, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
Incorrect Answers
“use packet errors and switch counters to isolate poor network performance” is related to another task, not the failure shown here. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
That choice concerns “test DNS dependencies separately from raw IP connectivity”, not the immediate requirement. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
The proposed action addresses “choose lif service policies and failover groups for supported protocols” rather than the problem described. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Question 547
A storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. Why does the recommended approach address this particular concern?
Explanation
Correct Answer
The situation is that a storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. A link can pass small probes while larger frames are dropped because one device does not support the configured packet size. This supports the decision to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used.
Incorrect Answers
“use interface groups only with matching switch link configuration” describes another technical distinction. Here, a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
“trace gateway and routing errors for remote storage clients” explains a different mechanism. Here, a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
The principle behind “use packet errors and switch counters to isolate poor network performance” is not the one being tested. Here, a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Question 548
A storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. Which evidence best validates the proposed outcome?
Explanation
Correct Answer
The situation is that a storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. Run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path. It is the relevant test because a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Incorrect Answers
That test concerns “trace gateway and routing errors for remote storage clients”, not the requested outcome. To check this result, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
The proposed check is relevant to “use interface groups only with matching switch link configuration”, but not sufficient here. To check this result, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
This evidence addresses “test DNS dependencies separately from raw IP connectivity” instead of confirming the repair. To check this result, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
Question 549
Consider this situation: A storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. A team member suggests: "Enable jumbo frames only on storage ports and assume all switches and clients automatically use the same MTU." What is the main risk?
Explanation
Correct Answer
The situation is that a storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. Large I/O requests can stall or retransmit despite apparently healthy small-packet network pings. The shortcut is unsafe because a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Incorrect Answers
The alternative risk relates to “Throughput remains unstable and error recovery consumes time despite no storage volume change”, not the stated mistake. Here, large I/O requests can stall or retransmit despite apparently healthy small-packet network pings.
“Client services may not reach gateways or violate the intended network separation design” can arise elsewhere, but it is not the most direct risk here. Here, large I/O requests can stall or retransmit despite apparently healthy small-packet network pings.
That consequence concerns “The network outage persists and security is weakened unnecessarily”, which is a different failure. Here, large I/O requests can stall or retransmit despite apparently healthy small-packet network pings.
Question 550
A storage operations lead considers: A storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. Which response and evidence should be linked?
Explanation
Correct Answer
The situation is that a storage team must determine whether packet loss is caused by mismatch between client and ONTAP network MTU. Confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. Validation: Run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path. The action and test belong together because a link can pass small probes while larger frames are dropped because one device does not support the configured packet size.
Incorrect Answers
“trace gateway and routing errors for remote storage clients” evaluates a different intervention. The appropriate action is to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. To confirm, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
That action-and-evidence pair concerns “choose lif service policies and failover groups for supported protocols”, not this decision. The appropriate action is to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. To confirm, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
The proposed pair focuses on “use packet errors and switch counters to isolate poor network performance” instead. The appropriate action is to confirm end-to-end supported MTU and interface settings for host, storage and switch paths when jumbo frames are used. To confirm, run a controlled size-appropriate network test and inspect switch drops and ONTAP port counters across the full path.
NetApp Certified Data Administrator, ONTAP (NS0-165) Practice Tests
- Network Appliance NS0-165 Practice Test 53 - 10 Questions (Last Reviewed 27-Sep-2026)
- Network Appliance NS0-165 Practice Test 54 - 10 Questions (Last Reviewed 26-Sep-2026)
- Network Appliance NS0-165 Practice Test 55 - 10 Questions (Last Reviewed 25-Sep-2026)
- Network Appliance NS0-165 Practice Test 56 - 10 Questions (Last Reviewed 24-Sep-2026)
- Network Appliance NS0-165 Practice Test 57 - 10 Questions (Last Reviewed 19-Nov-2026)