Practice Exams:

HP HPE7-A01 Dumps

EXAM: HPE Network Campus Access Professional
Verified By Experts
Premium Bundle
$19.99
$54.99 $74.98

HPE7-A01 Premium Bundle


  • Premium File 204 Questions & Answers
  • Study Guide 1264 Pages

HP HPE7-A01 Practice Test 21

Question 200

At a city-government services campus, the support engineering team reports that a visitor connects an unmanaged switch that sends bridge BPDUs on a protected edge port. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Check LACP partner identity and active member counts from the access switch
  2. Apply BPDU protection to designated edge ports and recover only after the loop source is addressed
  3. Inject a safe BPDU in a lab and confirm the expected port protection
  4. Place the specific policy entry at the appropriate precedence and verify counters
  5. Configure and validate the intended LLDP-MED voice network policy and access VLANs

Explanation

Correct Answers

B:

The selected action is Apply BPDU protection to designated edge ports and recover only after the loop source is addressed.

C:

The selected action is Inject a safe BPDU in a lab and confirm the expected port protection.

Incorrect Answers

A:

The proposed alternative—check LACP partner identity and active member counts from the access switch—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.

D:

The proposed alternative—place the specific policy entry at the appropriate precedence and verify counters—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.

E:

The proposed alternative—configure and validate the intended LLDP-MED voice network policy and access VLANs—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.

Question 201

At a university residence hall, the technical team reports that a failed access uplink takes longer to restore alternate forwarding than the campus design allows. Which configuration or operating decision most directly addresses the issue?

  1. Review RSTP topology roles and edge-port settings before adjusting timers
  2. Set the untagged access VLAN to the approved employee network
  3. Enable and verify IGMP snooping and an appropriate querier design for the VLAN
  4. Explain and validate the selected hash algorithm using multiple independent flows

Explanation

Correct Answer

A:

Review RSTP topology roles and edge-port settings before adjusting timers. Rapid spanning-tree roles and correct link types allow controlled convergence. Confirm the result using this test: Fail a redundant link and record port roles and reconvergence time.

Incorrect Answers

B:

The proposed alternative—set the untagged access VLAN to the approved employee network—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

C:

The proposed alternative—enable and verify IGMP snooping and an appropriate querier design for the VLAN—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

D:

The proposed alternative—explain and validate the selected hash algorithm using multiple independent flows—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

Question 202

At a university residence hall, the technical team reports that a failed access uplink takes longer to restore alternate forwarding than the campus design allows. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Mirror an unrelated trunk and claim it represents the affected AP interface
  2. Add a wireless SSID and expect it to move a wired access port into another VLAN
  3. Configure one member as an unrelated standalone LAG and expect seamless failover
  4. Disable spanning tree on both parallel uplinks to eliminate delays

Explanation

Correct Answer

D:

The shortcut at issue is to disable spanning tree on both parallel uplinks to eliminate delays. The corrective choice is: Review RSTP topology roles and edge-port settings before adjusting timers.

Incorrect Answers

A:

The shortcut to mirror an unrelated trunk and claim it represents the affected AP interface is not the error in this case. The actual risk comes from disable spanning tree on both parallel uplinks to eliminate delays.

B:

The shortcut to add a wireless SSID and expect it to move a wired access port into another VLAN is not the error in this case. The actual risk comes from disable spanning tree on both parallel uplinks to eliminate delays.

C:

The shortcut to configure one member as an unrelated standalone LAG and expect seamless failover is not the error in this case. The actual risk comes from disable spanning tree on both parallel uplinks to eliminate delays.

Question 203

At a university residence hall, the technical team reports that a failed access uplink takes longer to restore alternate forwarding than the campus design allows. Which technical reasoning most specifically justifies the recommended solution?

  1. A shared VLAN alone does not provide endpoint-to-endpoint isolation
  2. Rapid spanning-tree roles and correct link types allow controlled convergence
  3. Consistent multichassis aggregation requires both peers to participate correctly
  4. Relay forwards client broadcasts across routed network boundaries to the server

Explanation

Correct Answer

B:

Rapid spanning-tree roles and correct link types allow controlled convergence. This is the technical reason behind the proposed approach: “Review RSTP topology roles and edge-port settings before adjusting timers”. The result should be checked by “Fail a redundant link and record port roles and reconvergence time”.

Incorrect Answers

A:

The proposed alternative—a shared VLAN alone does not provide endpoint-to-endpoint isolation—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

C:

The proposed alternative—consistent multichassis aggregation requires both peers to participate correctly—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

D:

The proposed alternative—relay forwards client broadcasts across routed network boundaries to the server—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

Question 204

At a university residence hall, the technical team reports that a failed access uplink takes longer to restore alternate forwarding than the campus design allows. Which test would most directly show that the requested outcome was achieved?

  1. Inspect MAC move logs and port topology before and after correction
  2. Inspect stack member state and independent management identities
  3. Capture Discover and relayed DHCP packets on both sides
  4. Fail a redundant link and record port roles and reconvergence time

Explanation

Correct Answer

D:

The outcome check is to fail a redundant link and record port roles and reconvergence time. It measures whether the stated requirement was met.

Incorrect Answers

A:

The proposed alternative—inspect MAC move logs and port topology before and after correction—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

B:

The proposed alternative—inspect stack member state and independent management identities—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

C:

The proposed alternative—capture Discover and relayed DHCP packets on both sides—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

Question 205

At a university residence hall, the technical team reports that a failed access uplink takes longer to restore alternate forwarding than the campus design allows. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Inspect optics, light levels and cabling before retuning routing protocols
  2. Inspect partner system IDs and collecting/distributing member state
  3. Distinguish a supported VSF stack from an ordinary aggregate across separate systems
  4. Review RSTP topology roles and edge-port settings before adjusting timers
  5. Fail a redundant link and record port roles and reconvergence time

Explanation

Correct Answers

D:

The selected action is Review RSTP topology roles and edge-port settings before adjusting timers.

E:

The selected action is Fail a redundant link and record port roles and reconvergence time.

Incorrect Answers

A:

The proposed alternative—inspect optics, light levels and cabling before retuning routing protocols—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

B:

The proposed alternative—inspect partner system IDs and collecting/distributing member state—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

C:

The proposed alternative—distinguish a supported VSF stack from an ordinary aggregate across separate systems—does not address the current failure. Instead, review RSTP topology roles and edge-port settings before adjusting timers.

Question 206

At a regional retail distribution center, the infrastructure team reports that two campus distribution switches form a spanning-tree boundary because MST settings disagree. Which configuration or operating decision most directly addresses the issue?

  1. Verify consistent supported MTU along every forwarding link and VLAN interface in the path
  2. Apply BPDU protection to designated edge ports and recover only after the loop source is addressed
  3. Align MST region name, revision and VLAN-to-instance mapping on intended peers
  4. Align the reviewed native VLAN design and tagging expectations at both peers

Explanation

Correct Answer

C:

Align MST region name, revision and VLAN-to-instance mapping on intended peers. An MST region requires matching configuration to share consistent instances. Confirm the result using this test: Compare MST digests, region parameters and root instances.

Incorrect Answers

A:

The proposed alternative—verify consistent supported MTU along every forwarding link and VLAN interface in the path—does not address this requirement. An MST region requires matching configuration to share consistent instances.

B:

The proposed alternative—apply BPDU protection to designated edge ports and recover only after the loop source is addressed—does not address this requirement. An MST region requires matching configuration to share consistent instances.

D:

The proposed alternative—align the reviewed native VLAN design and tagging expectations at both peers—does not address this requirement. An MST region requires matching configuration to share consistent instances.

Question 207

At a regional retail distribution center, the infrastructure team reports that two campus distribution switches form a spanning-tree boundary because MST settings disagree. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Promise one TCP conversation the sum of all member bandwidth
  2. Raise the client MTU alone and ignore intermediate switch limits
  3. Increase broadcast storm thresholds so multicast gets forwarded only to subscribers
  4. Set only the same switch hostname and assume it joins the MST region

Explanation

Correct Answer

D:

The shortcut at issue is to set only the same switch hostname and assume it joins the MST region. An MST region requires matching configuration to share consistent instances. The corrective choice is: Align MST region name, revision and VLAN-to-instance mapping on intended peers.

Incorrect Answers

A:

The shortcut to promise one TCP conversation the sum of all member bandwidth is not the error in this case. The actual risk comes from set only the same switch hostname and assume it joins the MST region.

B:

The shortcut to raise the client MTU alone and ignore intermediate switch limits is not the error in this case. The actual risk comes from set only the same switch hostname and assume it joins the MST region.

C:

The shortcut to increase broadcast storm thresholds so multicast gets forwarded only to subscribers is not the error in this case. The actual risk comes from set only the same switch hostname and assume it joins the MST region.

Question 208

At a regional retail distribution center, the infrastructure team reports that two campus distribution switches form a spanning-tree boundary because MST settings disagree. Which technical reasoning most specifically justifies the recommended solution?

  1. An MST region requires matching configuration to share consistent instances
  2. SVIs supply the Layer-3 boundary between separate Layer-2 VLANs
  3. A VLAN must be carried end-to-end across every required trunk segment
  4. LAG selection is normally per flow, not automatic packet striping of one session

Explanation

Correct Answer

A:

An MST region requires matching configuration to share consistent instances. This is the technical reason behind the proposed approach: “Align MST region name, revision and VLAN-to-instance mapping on intended peers”. The result should be checked by “Compare MST digests, region parameters and root instances”.

Incorrect Answers

B:

The proposed alternative—sVIs supply the Layer-3 boundary between separate Layer-2 VLANs—does not address this requirement. An MST region requires matching configuration to share consistent instances.

C:

The proposed alternative—a VLAN must be carried end-to-end across every required trunk segment—does not address this requirement. An MST region requires matching configuration to share consistent instances.

D:

The proposed alternative—lAG selection is normally per flow, not automatic packet striping of one session—does not address this requirement. An MST region requires matching configuration to share consistent instances.

Question 209

At a regional retail distribution center, the infrastructure team reports that two campus distribution switches form a spanning-tree boundary because MST settings disagree. Which test would most directly show that the requested outcome was achieved?

  1. Capture Discover and relayed DHCP packets on both sides
  2. Ping each SVI and trace permitted cross-VLAN traffic
  3. Inspect the trunk list and verify required VLAN reachability remains
  4. Compare MST digests, region parameters and root instances

Explanation

Correct Answer

D:

The outcome check is to compare MST digests, region parameters and root instances. It measures whether the stated requirement was met. An MST region requires matching configuration to share consistent instances.

Incorrect Answers

A:

The suggested check—capture Discover and relayed DHCP packets on both sides—does not test the required result. Instead, compare MST digests, region parameters and root instances.

B:

The suggested check—ping each SVI and trace permitted cross-VLAN traffic—does not test the required result. Instead, compare MST digests, region parameters and root instances.

C:

The suggested check—inspect the trunk list and verify required VLAN reachability remains—does not test the required result. Instead, compare MST digests, region parameters and root instances.

Question 210

At a regional retail distribution center, the infrastructure team reports that two campus distribution switches form a spanning-tree boundary because MST settings disagree. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Compare MST digests, region parameters and root instances
  2. Configure the correct DHCP relay destination on the VLAN gateway interface
  3. Inspect MAC move logs and port topology before and after correction
  4. Align MST region name, revision and VLAN-to-instance mapping on intended peers
  5. Apply IPv6 router-advertisement guard on untrusted access ports where supported

Explanation

Correct Answers

A:

The selected action is Compare MST digests, region parameters and root instances. Its matching outcome check is to compare MST digests, region parameters and root instances.

D:

The selected action is Align MST region name, revision and VLAN-to-instance mapping on intended peers. Its matching outcome check is to compare MST digests, region parameters and root instances.

Incorrect Answers

B:

The proposed alternative—configure the correct DHCP relay destination on the VLAN gateway interface—does not address this requirement. An MST region requires matching configuration to share consistent instances.

C:

The proposed alternative—inspect MAC move logs and port topology before and after correction—does not address this requirement. An MST region requires matching configuration to share consistent instances.

E:

The proposed alternative—apply IPv6 router-advertisement guard on untrusted access ports where supported—does not address this requirement. An MST region requires matching configuration to share consistent instances.

HPE Network Campus Access Professional (HPE7-A01) Practice Tests