HP HPE7-A01 Dumps
HP HPE7-A01 Practice Test 19
Question 180
At a large school district, the IT team reports that a desktop connected to an Aruba CX access port receives an address from the visitor subnet. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Set the untagged access VLAN to the approved employee network. Its matching outcome check is to verify VLAN membership, DHCP scope and client reachability.
The selected action is Verify VLAN membership, DHCP scope and client reachability. Its matching outcome check is to verify VLAN membership, DHCP scope and client reachability.
Incorrect Answers
The proposed alternative—enable and verify IGMP snooping and an appropriate querier design for the VLAN—does not address the current failure. Instead, set the untagged access VLAN to the approved employee network.
The proposed alternative—test permitted and blocked traffic while inspecting rule hit counts—does not address the current failure. Instead, set the untagged access VLAN to the approved employee network.
The proposed alternative—create or validate the routed VLAN interfaces and approved inter-VLAN access policy—does not address the current failure. Instead, set the untagged access VLAN to the approved employee network.
Question 181
At a regional hospital network, the network team reports that new finance desks lose service because the finance VLAN is absent from one distribution trunk. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs. A VLAN must be carried end-to-end across every required trunk segment. Confirm the result using this test: Inspect the allowed VLAN lists and traffic counters on both trunks.
Incorrect Answers
The proposed alternative—verify consistent supported MTU along every forwarding link and VLAN interface in the path—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
The proposed alternative—mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
The proposed alternative—distinguish a supported VSF stack from an ordinary aggregate across separate systems—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
Question 182
At a regional hospital network, the network team reports that new finance desks lose service because the finance VLAN is absent from one distribution trunk. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to set the client IP subnet correctly and ignore missing intermediate VLAN transport. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs. The corrective choice is: Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
Incorrect Answers
The shortcut to set a high multicast address limit without addressing the broadcast traffic is not the error in this case. The actual risk comes from set the client IP subnet correctly and ignore missing intermediate VLAN transport.
The shortcut to raise the client MTU alone and ignore intermediate switch limits is not the error in this case. The actual risk comes from set the client IP subnet correctly and ignore missing intermediate VLAN transport.
The shortcut to allow all VLANs on every trunk because a shared physical uplink exists is not the error in this case. The actual risk comes from set the client IP subnet correctly and ignore missing intermediate VLAN transport.
Question 183
At a regional hospital network, the network team reports that new finance desks lose service because the finance VLAN is absent from one distribution trunk. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
A VLAN must be carried end-to-end across every required trunk segment. This is the technical reason behind the proposed approach: “Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs”. The result should be checked by “Inspect the allowed VLAN lists and traffic counters on both trunks”.
Incorrect Answers
The proposed alternative—pruning reduces unnecessary Layer-2 propagation and accidental exposure—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
The proposed alternative—rA guard can prevent rogue router advertisements from client-facing interfaces—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
The proposed alternative—lAG selection is normally per flow, not automatic packet striping of one session—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
Question 184
At a regional hospital network, the network team reports that new finance desks lose service because the finance VLAN is absent from one distribution trunk. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to inspect the allowed VLAN lists and traffic counters on both trunks. It measures whether the stated requirement was met. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
Incorrect Answers
The suggested check—check LACP partner identity and active member counts from the access switch—does not test the required result. Instead, inspect the allowed VLAN lists and traffic counters on both trunks.
The suggested check—inject a test rogue RA and verify client default-gateway selection—does not test the required result. Instead, inspect the allowed VLAN lists and traffic counters on both trunks.
The suggested check—inspect multicast group membership and receiving ports—does not test the required result. Instead, inspect the allowed VLAN lists and traffic counters on both trunks.
Question 185
At a regional hospital network, the network team reports that new finance desks lose service because the finance VLAN is absent from one distribution trunk. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Inspect the allowed VLAN lists and traffic counters on both trunks. Its matching outcome check is to inspect the allowed VLAN lists and traffic counters on both trunks.
The selected action is Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs. Its matching outcome check is to inspect the allowed VLAN lists and traffic counters on both trunks.
Incorrect Answers
The proposed alternative—review RSTP topology roles and edge-port settings before adjusting timers—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
The proposed alternative—enable and verify IGMP snooping and an appropriate querier design for the VLAN—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
The proposed alternative—inspect LLDP-MED advertisement and phone VLAN assignment—does not address this requirement. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs.
Question 186
At an industrial manufacturing site, the network engineering team reports that a switch uplink forwards untagged management frames to a different VLAN on the far end. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Align the reviewed native VLAN design and tagging expectations at both peers. Untagged frames use the native VLAN, so mismatched settings change their destination. Confirm the result using this test: Trace untagged frames and verify management subnet consistency.
Incorrect Answers
The proposed alternative—align MC-LAG identifiers and the supported VSX peer configuration—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—apply supported ARP inspection using valid bindings and trusted network ports—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
Question 187
At an industrial manufacturing site, the network engineering team reports that a switch uplink forwards untagged management frames to a different VLAN on the far end. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to assume tagging all other VLANs also corrects the native VLAN mismatch. The corrective choice is: Align the reviewed native VLAN design and tagging expectations at both peers.
Incorrect Answers
The shortcut to configure one member as an unrelated standalone LAG and expect seamless failover is not the error in this case. The actual risk comes from assuming tagging all other VLANs also corrects the native VLAN mismatch.
The shortcut to block only the internet gateway and assume local peer traffic is stopped is not the error in this case. The actual risk comes from assuming tagging all other VLANs also corrects the native VLAN mismatch.
The shortcut to set only the same switch hostname and assume it joins the MST region is not the error in this case. The actual risk comes from assuming tagging all other VLANs also corrects the native VLAN mismatch.
Question 188
At an industrial manufacturing site, the network engineering team reports that a switch uplink forwards untagged management frames to a different VLAN on the far end. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
Untagged frames use the native VLAN, so mismatched settings change their destination. This is the technical reason behind the proposed approach: “Align the reviewed native VLAN design and tagging expectations at both peers”. The result should be checked by “Trace untagged frames and verify management subnet consistency”.
Incorrect Answers
The proposed alternative—ordered ACL evaluation can cause a broad earlier match to bypass a later rule—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—a shared VLAN alone does not provide endpoint-to-endpoint isolation—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—aggregation alone does not merge device management or create one stack identity—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
Question 189
At an industrial manufacturing site, the network engineering team reports that a switch uplink forwards untagged management frames to a different VLAN on the far end. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to trace untagged frames and verify management subnet consistency. It measures whether the stated requirement was met.
Incorrect Answers
The suggested check—correlate CRC increments with optic diagnostics and corrected media—does not test the required result. Instead, trace untagged frames and verify management subnet consistency.
The suggested check—test permitted and blocked traffic while inspecting rule hit counts—does not test the required result. Instead, trace untagged frames and verify management subnet consistency.
The suggested check—inspect partner system IDs and collecting/distributing member state—does not test the required result. Instead, trace untagged frames and verify management subnet consistency.
Question 190
At an industrial manufacturing site, the network engineering team reports that a switch uplink forwards untagged management frames to a different VLAN on the far end. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Trace untagged frames and verify management subnet consistency. Its matching outcome check is to trace untagged frames and verify management subnet consistency.
The selected action is Align the reviewed native VLAN design and tagging expectations at both peers. Its matching outcome check is to trace untagged frames and verify management subnet consistency.
Incorrect Answers
The proposed alternative—inspect MAC move logs and port topology before and after correction—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—restrict permitted VLANs on trunk paths to those legitimately required—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—verify LACP mode, member speed and matching aggregation configuration—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
HPE Network Campus Access Professional (HPE7-A01) Practice Tests
- HP HPE7-A01 Practice Test 17 - 10 Questions (Last Reviewed 02-Nov-2026)
- HP HPE7-A01 Practice Test 18 - 10 Questions (Last Reviewed 01-Nov-2026)
- HP HPE7-A01 Practice Test 19 - 10 Questions (Last Reviewed 31-Oct-2026)
- HP HPE7-A01 Practice Test 20 - 10 Questions (Last Reviewed 30-Oct-2026)
- HP HPE7-A01 Practice Test 21 - 10 Questions (Last Reviewed 29-Oct-2026)