Practice Exams:

HP HPE7-A01 Dumps

EXAM: HPE Network Campus Access Professional
Verified By Experts
Premium Bundle
$19.99
$54.99 $74.98

HPE7-A01 Premium Bundle


  • Premium File 204 Questions & Answers
  • Study Guide 1264 Pages

HP HPE7-A01 Practice Test 22

Question 210

At a regional retail distribution center, the infrastructure team reports that two campus distribution switches form a spanning-tree boundary because MST settings disagree. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Compare MST digests, region parameters and root instances
  2. Configure the correct DHCP relay destination on the VLAN gateway interface
  3. Inspect MAC move logs and port topology before and after correction
  4. Align MST region name, revision and VLAN-to-instance mapping on intended peers
  5. Apply IPv6 router-advertisement guard on untrusted access ports where supported

Explanation

Correct Answers

A:

The selected action is Compare MST digests, region parameters and root instances. Its matching outcome check is to compare MST digests, region parameters and root instances.

D:

The selected action is Align MST region name, revision and VLAN-to-instance mapping on intended peers. Its matching outcome check is to compare MST digests, region parameters and root instances.

Incorrect Answers

B:

The proposed alternative—configure the correct DHCP relay destination on the VLAN gateway interface—does not address this requirement. An MST region requires matching configuration to share consistent instances.

C:

The proposed alternative—inspect MAC move logs and port topology before and after correction—does not address this requirement. An MST region requires matching configuration to share consistent instances.

E:

The proposed alternative—apply IPv6 router-advertisement guard on untrusted access ports where supported—does not address this requirement. An MST region requires matching configuration to share consistent instances.

Question 211

At an international convention venue, the wireless support team reports that a switch LAG shows only one active member after an additional cable is connected. Which configuration or operating decision most directly addresses the issue?

  1. Align the reviewed native VLAN design and tagging expectations at both peers
  2. Verify LACP mode, member speed and matching aggregation configuration
  3. Set the untagged access VLAN to the approved employee network
  4. Configure the correct DHCP relay destination on the VLAN gateway interface

Explanation

Correct Answer

B:

Verify LACP mode, member speed and matching aggregation configuration. LACP members must agree on the aggregate and compatible link parameters. Confirm the result using this test: Inspect partner system IDs and collecting/distributing member state.

Incorrect Answers

A:

The proposed alternative—align the reviewed native VLAN design and tagging expectations at both peers—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

C:

The proposed alternative—set the untagged access VLAN to the approved employee network—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

D:

The proposed alternative—configure the correct DHCP relay destination on the VLAN gateway interface—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

Question 212

At an international convention venue, the wireless support team reports that a switch LAG shows only one active member after an additional cable is connected. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Increase the MAC aging time and assume the underlying loop disappears
  2. Add a static default route on clients that have not yet received addresses
  3. Promise one TCP conversation the sum of all member bandwidth
  4. Force a static aggregate on one end while keeping LACP active on the other

Explanation

Correct Answer

D:

The shortcut at issue is to force a static aggregate on one end while keeping LACP active on the other. LACP members must agree on the aggregate and compatible link parameters. The corrective choice is: Verify LACP mode, member speed and matching aggregation configuration.

Incorrect Answers

A:

The shortcut to increase the MAC aging time and assume the underlying loop disappears is not the error in this case. The actual risk comes from force a static aggregate on one end while keeping LACP active on the other.

B:

The shortcut to add a static default route on clients that have not yet received addresses is not the error in this case. The actual risk comes from force a static aggregate on one end while keeping LACP active on the other.

C:

The shortcut to promise one TCP conversation the sum of all member bandwidth is not the error in this case. The actual risk comes from force a static aggregate on one end while keeping LACP active on the other.

Question 213

At an international convention venue, the wireless support team reports that a switch LAG shows only one active member after an additional cable is connected. Which technical reasoning most specifically justifies the recommended solution?

  1. CRC errors indicate link-level corruption that may be caused by physical conditions
  2. Rapid MAC movement can signal a loop or multi-path attachment without a valid aggregate
  3. Phones can learn voice VLAN parameters through link-layer discovery
  4. LACP members must agree on the aggregate and compatible link parameters

Explanation

Correct Answer

D:

LACP members must agree on the aggregate and compatible link parameters. This is the technical reason behind the proposed approach: “Verify LACP mode, member speed and matching aggregation configuration”. The result should be checked by “Inspect partner system IDs and collecting/distributing member state”.

Incorrect Answers

A:

The proposed alternative—cRC errors indicate link-level corruption that may be caused by physical conditions—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

B:

The proposed alternative—rapid MAC movement can signal a loop or multi-path attachment without a valid aggregate—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

C:

The proposed alternative—phones can learn voice VLAN parameters through link-layer discovery—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

Question 214

At an international convention venue, the wireless support team reports that a switch LAG shows only one active member after an additional cable is connected. Which test would most directly show that the requested outcome was achieved?

  1. Inspect partner system IDs and collecting/distributing member state
  2. Correlate CRC increments with optic diagnostics and corrected media
  3. Validate the capture contains the expected source MAC and VLAN tags
  4. Compare MST digests, region parameters and root instances

Explanation

Correct Answer

A:

The outcome check is to inspect partner system IDs and collecting/distributing member state. It measures whether the stated requirement was met. LACP members must agree on the aggregate and compatible link parameters.

Incorrect Answers

B:

The suggested check—correlate CRC increments with optic diagnostics and corrected media—does not test the required result. Instead, inspect partner system IDs and collecting/distributing member state.

C:

The suggested check—validate the capture contains the expected source MAC and VLAN tags—does not test the required result. Instead, inspect partner system IDs and collecting/distributing member state.

D:

The suggested check—compare MST digests, region parameters and root instances—does not test the required result. Instead, inspect partner system IDs and collecting/distributing member state.

Question 215

At an international convention venue, the wireless support team reports that a switch LAG shows only one active member after an additional cable is connected. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Apply IPv6 router-advertisement guard on untrusted access ports where supported
  2. Inspect partner system IDs and collecting/distributing member state
  3. Verify LACP mode, member speed and matching aggregation configuration
  4. Align MST region name, revision and VLAN-to-instance mapping on intended peers
  5. Fail a redundant link and record port roles and reconvergence time

Explanation

Correct Answers

B:

The selected action is Inspect partner system IDs and collecting/distributing member state. Its matching outcome check is to inspect partner system IDs and collecting/distributing member state.

C:

The selected action is Verify LACP mode, member speed and matching aggregation configuration. Its matching outcome check is to inspect partner system IDs and collecting/distributing member state.

Incorrect Answers

A:

The proposed alternative—apply IPv6 router-advertisement guard on untrusted access ports where supported—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

D:

The proposed alternative—align MST region name, revision and VLAN-to-instance mapping on intended peers—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

E:

The proposed alternative—fail a redundant link and record port roles and reconvergence time—does not address this requirement. LACP members must agree on the aggregate and compatible link parameters.

Question 216

At an airport administration network, the wireless engineering team reports that a file transfer does not exceed one link rate on a multi-link Aruba CX aggregate. Which configuration or operating decision most directly addresses the issue?

  1. Explain and validate the selected hash algorithm using multiple independent flows
  2. Align MC-LAG identifiers and the supported VSX peer configuration
  3. Place the specific policy entry at the appropriate precedence and verify counters
  4. Review RSTP topology roles and edge-port settings before adjusting timers

Explanation

Correct Answer

A:

Explain and validate the selected hash algorithm using multiple independent flows. LAG selection is normally per flow, not automatic packet striping of one session. Confirm the result using this test: Measure per-member counters across several separate flows.

Incorrect Answers

B:

The proposed alternative—align MC-LAG identifiers and the supported VSX peer configuration—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

C:

The proposed alternative—place the specific policy entry at the appropriate precedence and verify counters—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

D:

The proposed alternative—review RSTP topology roles and edge-port settings before adjusting timers—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

Question 217

At an airport administration network, the wireless engineering team reports that a file transfer does not exceed one link rate on a multi-link Aruba CX aggregate. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Allow all VLANs on every trunk because a shared physical uplink exists
  2. Disable spanning tree on both parallel uplinks to eliminate delays
  3. Mirror an unrelated trunk and claim it represents the affected AP interface
  4. Promise one TCP conversation the sum of all member bandwidth

Explanation

Correct Answer

D:

The shortcut at issue is to promise one TCP conversation the sum of all member bandwidth. The corrective choice is: Explain and validate the selected hash algorithm using multiple independent flows.

Incorrect Answers

A:

The shortcut to allow all VLANs on every trunk because a shared physical uplink exists is not the error in this case. The actual risk comes from promise one TCP conversation the sum of all member bandwidth.

B:

The shortcut to disable spanning tree on both parallel uplinks to eliminate delays is not the error in this case. The actual risk comes from promise one TCP conversation the sum of all member bandwidth.

C:

The shortcut to mirror an unrelated trunk and claim it represents the affected AP interface is not the error in this case. The actual risk comes from promise one TCP conversation the sum of all member bandwidth.

Question 218

At an airport administration network, the wireless engineering team reports that a file transfer does not exceed one link rate on a multi-link Aruba CX aggregate. Which technical reasoning most specifically justifies the recommended solution?

  1. Access ports assign untagged endpoints to their configured local VLAN
  2. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability
  3. Port mirroring provides a copy of observed frames for packet analysis
  4. LAG selection is normally per flow, not automatic packet striping of one session

Explanation

Correct Answer

D:

LAG selection is normally per flow, not automatic packet striping of one session. This is the technical reason behind the proposed approach: “Explain and validate the selected hash algorithm using multiple independent flows”. The result should be checked by “Measure per-member counters across several separate flows”.

Incorrect Answers

A:

The proposed alternative—access ports assign untagged endpoints to their configured local VLAN—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

B:

The proposed alternative—an edge-port BPDU can indicate an unexpected bridge that threatens topology stability—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

C:

The proposed alternative—port mirroring provides a copy of observed frames for packet analysis—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

Question 219

At an airport administration network, the wireless engineering team reports that a file transfer does not exceed one link rate on a multi-link Aruba CX aggregate. Which test would most directly show that the requested outcome was achieved?

  1. Verify VLAN membership, DHCP scope and client reachability
  2. Ping each SVI and trace permitted cross-VLAN traffic
  3. Measure per-member counters across several separate flows
  4. Inject a harmless rogue offer and confirm it is blocked

Explanation

Correct Answer

C:

The outcome check is to measure per-member counters across several separate flows. It measures whether the stated requirement was met.

Incorrect Answers

A:

The suggested check—verify VLAN membership, DHCP scope and client reachability—does not test the required result. Instead, measure per-member counters across several separate flows.

B:

The suggested check—ping each SVI and trace permitted cross-VLAN traffic—does not test the required result. Instead, measure per-member counters across several separate flows.

D:

The suggested check—inject a harmless rogue offer and confirm it is blocked—does not test the required result. Instead, measure per-member counters across several separate flows.

Question 220

At an airport administration network, the wireless engineering team reports that a file transfer does not exceed one link rate on a multi-link Aruba CX aggregate. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Inspect optics, light levels and cabling before retuning routing protocols
  2. Mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported
  3. Explain and validate the selected hash algorithm using multiple independent flows
  4. Inspect partner system IDs and collecting/distributing member state
  5. Measure per-member counters across several separate flows

Explanation

Correct Answers

C:

The selected action is Explain and validate the selected hash algorithm using multiple independent flows. Its matching outcome check is to measure per-member counters across several separate flows.

E:

The selected action is Measure per-member counters across several separate flows. Its matching outcome check is to measure per-member counters across several separate flows.

Incorrect Answers

A:

The proposed alternative—inspect optics, light levels and cabling before retuning routing protocols—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

B:

The proposed alternative—mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

D:

The proposed alternative—inspect partner system IDs and collecting/distributing member state—does not address the current failure. Instead, explain and validate the selected hash algorithm using multiple independent flows.

HPE Network Campus Access Professional (HPE7-A01) Practice Tests