HP HPE7-A01 Dumps
HP HPE7-A01 Practice Test 20
Question 190
At an industrial manufacturing site, the network engineering team reports that a switch uplink forwards untagged management frames to a different VLAN on the far end. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Trace untagged frames and verify management subnet consistency. Its matching outcome check is to trace untagged frames and verify management subnet consistency.
The selected action is Align the reviewed native VLAN design and tagging expectations at both peers. Its matching outcome check is to trace untagged frames and verify management subnet consistency.
Incorrect Answers
The proposed alternative—inspect MAC move logs and port topology before and after correction—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—restrict permitted VLANs on trunk paths to those legitimately required—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
The proposed alternative—verify LACP mode, member speed and matching aggregation configuration—does not address the current failure. Instead, align the reviewed native VLAN design and tagging expectations at both peers.
Question 191
At a university engineering campus, the engineering team reports that two guest devices on the same access switch can reach each other despite an isolation requirement. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Use a supported port-isolation or policy feature on their access ports. A shared VLAN alone does not provide endpoint-to-endpoint isolation. Confirm the result using this test: Test guest-to-guest denial while retaining approved gateway access.
Incorrect Answers
The proposed alternative—create or validate the routed VLAN interfaces and approved inter-VLAN access policy—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
The proposed alternative—align the reviewed native VLAN design and tagging expectations at both peers—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
The proposed alternative—apply appropriately scoped storm-control limits and repair the physical loop—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
Question 192
At a university engineering campus, the engineering team reports that two guest devices on the same access switch can reach each other despite an isolation requirement. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to block only the internet gateway and assume local peer traffic is stopped. The corrective choice is: Use a supported port-isolation or policy feature on their access ports.
Incorrect Answers
The shortcut to promise one TCP conversation the sum of all member bandwidth is not the error in this case. The actual risk comes from block only the internet gateway and assume local peer traffic is stopped.
The shortcut to add a wireless SSID and expect it to move a wired access port into another VLAN is not the error in this case. The actual risk comes from block only the internet gateway and assume local peer traffic is stopped.
The shortcut to set a high multicast address limit without addressing the broadcast traffic is not the error in this case. The actual risk comes from block only the internet gateway and assume local peer traffic is stopped.
Question 193
At a university engineering campus, the engineering team reports that two guest devices on the same access switch can reach each other despite an isolation requirement. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
A shared VLAN alone does not provide endpoint-to-endpoint isolation. This is the technical reason behind the proposed approach: “Use a supported port-isolation or policy feature on their access ports”. The result should be checked by “Test guest-to-guest denial while retaining approved gateway access”.
Incorrect Answers
The proposed alternative—snooping restricts multicast forwarding according to learned receiver memberships—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
The proposed alternative—access ports assign untagged endpoints to their configured local VLAN—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
The proposed alternative—an oversized frame fails wherever the path has an insufficient effective MTU—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
Question 194
At a university engineering campus, the engineering team reports that two guest devices on the same access switch can reach each other despite an isolation requirement. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to test guest-to-guest denial while retaining approved gateway access. It measures whether the stated requirement was met.
Incorrect Answers
The suggested check—inspect MAC move logs and port topology before and after correction—does not test the required result. Instead, test guest-to-guest denial while retaining approved gateway access.
The suggested check—send bounded size probes and inspect oversize or discard counters—does not test the required result. Instead, test guest-to-guest denial while retaining approved gateway access.
The suggested check—inject a harmless rogue offer and confirm it is blocked—does not test the required result. Instead, test guest-to-guest denial while retaining approved gateway access.
Question 195
At a university engineering campus, the engineering team reports that two guest devices on the same access switch can reach each other despite an isolation requirement. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Test guest-to-guest denial while retaining approved gateway access. Its matching outcome check is to test guest-to-guest denial while retaining approved gateway access.
The selected action is Use a supported port-isolation or policy feature on their access ports. Its matching outcome check is to test guest-to-guest denial while retaining approved gateway access.
Incorrect Answers
The proposed alternative—inspect partner system IDs and collecting/distributing member state—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
The proposed alternative—distinguish a supported VSF stack from an ordinary aggregate across separate systems—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
The proposed alternative—trace the physical loop or unauthorized bridge and review learned MAC movements—does not address the current failure. Instead, use a supported port-isolation or policy feature on their access ports.
Question 196
At a city-government services campus, the support engineering team reports that a visitor connects an unmanaged switch that sends bridge BPDUs on a protected edge port. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Apply BPDU protection to designated edge ports and recover only after the loop source is addressed. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability. Confirm the result using this test: Inject a safe BPDU in a lab and confirm the expected port protection.
Incorrect Answers
The proposed alternative—restrict permitted VLANs on trunk paths to those legitimately required—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—inspect optics, light levels and cabling before retuning routing protocols—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—apply appropriately scoped storm-control limits and repair the physical loop—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
Question 197
At a city-government services campus, the support engineering team reports that a visitor connects an unmanaged switch that sends bridge BPDUs on a protected edge port. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to increase the root bridge priority to hide the unauthorized bridge. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability. The corrective choice is: Apply BPDU protection to designated edge ports and recover only after the loop source is addressed.
Incorrect Answers
The shortcut to configure only additional access VLAN IDs and assume routing follows automatically is not the error in this case. The actual risk comes from increase the root bridge priority to hide the unauthorized bridge.
The shortcut to assume tagging all other VLANs also corrects the native VLAN mismatch is not the error in this case. The actual risk comes from increase the root bridge priority to hide the unauthorized bridge.
The shortcut to set a high multicast address limit without addressing the broadcast traffic is not the error in this case. The actual risk comes from increase the root bridge priority to hide the unauthorized bridge.
Question 198
At a city-government services campus, the support engineering team reports that a visitor connects an unmanaged switch that sends bridge BPDUs on a protected edge port. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
An edge-port BPDU can indicate an unexpected bridge that threatens topology stability. This is the technical reason behind the proposed approach: “Apply BPDU protection to designated edge ports and recover only after the loop source is addressed”. The result should be checked by “Inject a safe BPDU in a lab and confirm the expected port protection”.
Incorrect Answers
The proposed alternative—rapid MAC movement can signal a loop or multi-path attachment without a valid aggregate—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—untagged frames use the native VLAN, so mismatched settings change their destination—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—port mirroring provides a copy of observed frames for packet analysis—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
Question 199
At a city-government services campus, the support engineering team reports that a visitor connects an unmanaged switch that sends bridge BPDUs on a protected edge port. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to inject a safe BPDU in a lab and confirm the expected port protection. It measures whether the stated requirement was met. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
Incorrect Answers
The proposed alternative—inspect MAC move logs and port topology before and after correction—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—send bounded size probes and inspect oversize or discard counters—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—inspect LLDP-MED advertisement and phone VLAN assignment—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
Question 200
At a city-government services campus, the support engineering team reports that a visitor connects an unmanaged switch that sends bridge BPDUs on a protected edge port. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Apply BPDU protection to designated edge ports and recover only after the loop source is addressed.
The selected action is Inject a safe BPDU in a lab and confirm the expected port protection.
Incorrect Answers
The proposed alternative—check LACP partner identity and active member counts from the access switch—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—place the specific policy entry at the appropriate precedence and verify counters—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
The proposed alternative—configure and validate the intended LLDP-MED voice network policy and access VLANs—does not address this requirement. An edge-port BPDU can indicate an unexpected bridge that threatens topology stability.
HPE Network Campus Access Professional (HPE7-A01) Practice Tests
- HP HPE7-A01 Practice Test 18 - 10 Questions (Last Reviewed 01-Nov-2026)
- HP HPE7-A01 Practice Test 19 - 10 Questions (Last Reviewed 31-Oct-2026)
- HP HPE7-A01 Practice Test 20 - 10 Questions (Last Reviewed 30-Oct-2026)
- HP HPE7-A01 Practice Test 21 - 10 Questions (Last Reviewed 29-Oct-2026)
- HP HPE7-A01 Practice Test 22 - 10 Questions (Last Reviewed 28-Oct-2026)