HP HPE7-A01 Dumps
HP HPE7-A01 Practice Test 9
Question 80
At an international convention venue, the wireless support team reports that a shared switch template assigns the same gateway address at multiple sites. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Inspect rendered configuration for two sites and verify unique addresses. Its matching outcome check is to inspect rendered configuration for two sites and verify unique addresses.
The selected action is Separate common configuration from validated per-site addresses and interfaces. Its matching outcome check is to inspect rendered configuration for two sites and verify unique addresses.
Incorrect Answers
The proposed alternative—read transceiver diagnostics and optical power at each endpoint—does not address the current failure. Instead, separate common configuration from validated per-site addresses and interfaces.
The proposed alternative—inspect negotiation settings, transceiver and cable pairs before forcing speeds—does not address the current failure. Instead, separate common configuration from validated per-site addresses and interfaces.
The proposed alternative—reconcile serial numbers, site membership and device ownership before provisioning—does not address the current failure. Instead, separate common configuration from validated per-site addresses and interfaces.
Question 81
At an airport administration network, the wireless engineering team reports that a campus fiber uplink stays down after installing transceivers of mixed standards. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Verify optic type, wavelength, fiber distance and supported port mode on both ends. Matching optical characteristics and supported transceivers are required for physical service. Confirm the result using this test: Read transceiver diagnostics and optical power at each endpoint.
Incorrect Answers
The proposed alternative—test DNS lookup and resolver reachability before changing layer-3 routes—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—inspect scope utilization, exclusions and lease behavior before expanding capacity—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—reconcile serial numbers, site membership and device ownership before provisioning—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
Question 82
At an airport administration network, the wireless engineering team reports that a campus fiber uplink stays down after installing transceivers of mixed standards. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to assume matching connector shape implies compatible wavelengths. The corrective choice is: Verify optic type, wavelength, fiber distance and supported port mode on both ends.
Incorrect Answers
The shortcut to treat all unexpected reboots as routing-protocol convergence problems is not the error in this case. The actual risk comes from assuming matching connector shape implies compatible wavelengths.
The shortcut to rename the switch and assume that corrects its cloud ownership is not the error in this case. The actual risk comes from assuming matching connector shape implies compatible wavelengths.
The shortcut to restore an arbitrary older template without checking its site variables is not the error in this case. The actual risk comes from assuming matching connector shape implies compatible wavelengths.
Question 83
At an airport administration network, the wireless engineering team reports that a campus fiber uplink stays down after installing transceivers of mixed standards. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
Matching optical characteristics and supported transceivers are required for physical service. This is the technical reason behind the proposed approach: “Verify optic type, wavelength, fiber distance and supported port mode on both ends”. The result should be checked by “Read transceiver diagnostics and optical power at each endpoint”.
Incorrect Answers
The proposed alternative—configuration drift must be reconciled against an actual approved revision—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—negotiation and physical media faults can cap Ethernet link rate—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—address assignment alone does not establish controller or cloud discovery—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
Question 84
At an airport administration network, the wireless engineering team reports that a campus fiber uplink stays down after installing transceivers of mixed standards. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to read transceiver diagnostics and optical power at each endpoint. It measures whether the stated requirement was met.
Incorrect Answers
The proposed alternative—compare LLDP system IDs and interface descriptions at both peers—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—check negotiated speed, duplex and physical error counters—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—test one host in each segment and trace allowed and denied paths—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
Question 85
At an airport administration network, the wireless engineering team reports that a campus fiber uplink stays down after installing transceivers of mixed standards. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Verify optic type, wavelength, fiber distance and supported port mode on both ends.
The selected action is Read transceiver diagnostics and optical power at each endpoint.
Incorrect Answers
The proposed alternative—inspect rendered configuration for two sites and verify unique addresses—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—use LLDP neighbor identities and physical port observations to reconcile cabling—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
The proposed alternative—confirm the management VRF, default route, DNS and allowed egress independently—does not address the current failure. Instead, verify optic type, wavelength, fiber distance and supported port mode on both ends.
Question 86
At a public utility operations center, the network engineering team reports that a network management application fails by hostname but works when addressed by IP. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Test DNS lookup and resolver reachability before changing layer-3 routes. Name resolution may fail independently of an otherwise healthy IP path. Confirm the result using this test: Compare name resolution and direct IP connectivity from the client.
Incorrect Answers
The proposed alternative—reconcile serial numbers, site membership and device ownership before provisioning—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
The proposed alternative—plan documented VLANs, SSID role mapping and routed policy boundaries—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
The proposed alternative—confirm the management VRF, default route, DNS and allowed egress independently—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
Question 87
At a public utility operations center, the network engineering team reports that a network management application fails by hostname but works when addressed by IP. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to change default gateway metrics without checking DNS response content. The corrective choice is: Test DNS lookup and resolver reachability before changing layer-3 routes.
Incorrect Answers
The shortcut to assume a MAC address table always identifies the directly attached AP port is not the error in this case. The actual risk comes from change default gateway metrics without checking DNS response content.
The shortcut to increase AP transmit power to create more DHCP address capacity is not the error in this case. The actual risk comes from change default gateway metrics without checking DNS response content.
The shortcut to use one flat untagged VLAN and depend only on device names for separation is not the error in this case. The actual risk comes from change default gateway metrics without checking DNS response content.
Question 88
At a public utility operations center, the network engineering team reports that a network management application fails by hostname but works when addressed by IP. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
Name resolution may fail independently of an otherwise healthy IP path. This is the technical reason behind the proposed approach: “Test DNS lookup and resolver reachability before changing layer-3 routes”. The result should be checked by “Compare name resolution and direct IP connectivity from the client”.
Incorrect Answers
The proposed alternative—lLDP advertises adjacent devices and ports, not the complete end-to-end path—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
The proposed alternative—physical carrier does not guarantee the intended VLAN is transported—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
The proposed alternative—matching optical characteristics and supported transceivers are required for physical service—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
Question 89
At a public utility operations center, the network engineering team reports that a network management application fails by hostname but works when addressed by IP. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to compare name resolution and direct IP connectivity from the client. It measures whether the stated requirement was met.
Incorrect Answers
The suggested check—compare allowed VLANs and management connectivity at both ends—does not test the required result. Instead, compare name resolution and direct IP connectivity from the client.
The suggested check—examine DHCP options, resolved destinations and discovery logs—does not test the required result. Instead, compare name resolution and direct IP connectivity from the client.
The suggested check—correlate uptime reset events with power and temperature telemetry—does not test the required result. Instead, compare name resolution and direct IP connectivity from the client.
Question 90
At a public utility operations center, the network engineering team reports that a network management application fails by hostname but works when addressed by IP. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Test DNS lookup and resolver reachability before changing layer-3 routes. Its matching outcome check is to compare name resolution and direct IP connectivity from the client.
The selected action is Compare name resolution and direct IP connectivity from the client. Its matching outcome check is to compare name resolution and direct IP connectivity from the client.
Incorrect Answers
The proposed alternative—pilot the template on representative hardware and stage rollout with rollback points—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
The proposed alternative—generate a targeted configuration diff and confirm service after remediation—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
The proposed alternative—validate DNS resolution and discovery or provisioning parameters after DHCP—does not address the current failure. Instead, test DNS lookup and resolver reachability before changing layer-3 routes.
HPE Network Campus Access Professional (HPE7-A01) Practice Tests
- HP HPE7-A01 Practice Test 7 - 10 Questions (Last Reviewed 12-Nov-2026)
- HP HPE7-A01 Practice Test 8 - 10 Questions (Last Reviewed 11-Nov-2026)
- HP HPE7-A01 Practice Test 9 - 10 Questions (Last Reviewed 10-Nov-2026)
- HP HPE7-A01 Practice Test 10 - 10 Questions (Last Reviewed 09-Nov-2026)
- HP HPE7-A01 Practice Test 11 - 10 Questions (Last Reviewed 08-Nov-2026)