Practice Exams:

HP HPE7-A01 Dumps

EXAM: HPE Network Campus Access Professional
Verified By Experts
Premium Bundle
$19.99
$54.99 $74.98

HPE7-A01 Premium Bundle


  • Premium File 204 Questions & Answers
  • Study Guide 1264 Pages

HP HPE7-A01 Practice Test 49

Question 480

At a university engineering campus, the engineering team reports that OSPF neighbors stop forming immediately after one side enables key-based authentication. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Inspect authentication logs and a successful neighbor exchange
  2. Tie default-route origination to a valid upstream route or supported reachability condition
  3. Align the supported authentication method, keys and relevant lifetimes securely
  4. Apply reviewed inbound filtering and maximum-prefix policy for that peer
  5. Inspect area parameters and advertised default or external routes

Explanation

Correct Answers

A:

The selected action is Inspect authentication logs and a successful neighbor exchange. Its matching outcome check is to inspect authentication logs and a successful neighbor exchange.

C:

The selected action is Align the supported authentication method, keys and relevant lifetimes securely. Its matching outcome check is to inspect authentication logs and a successful neighbor exchange.

Incorrect Answers

B:

The proposed alternative—tie default-route origination to a valid upstream route or supported reachability condition—does not address the current failure. Instead, align the supported authentication method, keys and relevant lifetimes securely.

D:

The proposed alternative—apply reviewed inbound filtering and maximum-prefix policy for that peer—does not address the current failure. Instead, align the supported authentication method, keys and relevant lifetimes securely.

E:

The proposed alternative—inspect area parameters and advertised default or external routes—does not address the current failure. Instead, align the supported authentication method, keys and relevant lifetimes securely.

Question 481

At a city-government services campus, the support engineering team reports that the campus selects a slower backup path despite a preferred low-latency routed uplink. Which configuration or operating decision most directly addresses the issue?

  1. Configure the supported helper or relay on the client VLAN gateway
  2. Configure and validate the appropriate OSPFv3 instance, interfaces and area settings
  3. Use supported policy-based routing with ordered, narrowly matched traffic criteria
  4. Compare interface costs and installed OSPF paths before changing metrics

Explanation

Correct Answer

D:

Compare interface costs and installed OSPF paths before changing metrics. OSPF chooses paths based on its computed metrics and available topology. Confirm the result using this test: Verify best path and failover after a controlled cost change.

Incorrect Answers

A:

The proposed alternative—configure the supported helper or relay on the client VLAN gateway—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

B:

The proposed alternative—configure and validate the appropriate OSPFv3 instance, interfaces and area settings—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

C:

The proposed alternative—use supported policy-based routing with ordered, narrowly matched traffic criteria—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

Question 482

At a city-government services campus, the support engineering team reports that the campus selects a slower backup path despite a preferred low-latency routed uplink. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Always originate default from every campus router with no upstream check
  2. Change only the DNS suffix and expect egress routing to change by application
  3. Set interface descriptions to Primary and Backup and expect route cost to follow
  4. Expect an ordinary stub area to carry every AS-external LSA unchanged

Explanation

Correct Answer

C:

The shortcut at issue is to set interface descriptions to Primary and Backup and expect route cost to follow. The corrective choice is: Compare interface costs and installed OSPF paths before changing metrics.

Incorrect Answers

A:

The shortcut to always originate default from every campus router with no upstream check is not the error in this case. The actual risk comes from set interface descriptions to Primary and Backup and expect route cost to follow.

B:

The shortcut to change only the DNS suffix and expect egress routing to change by application is not the error in this case. The actual risk comes from set interface descriptions to Primary and Backup and expect route cost to follow.

D:

The shortcut to expect an ordinary stub area to carry every AS-external LSA unchanged is not the error in this case. The actual risk comes from set interface descriptions to Primary and Backup and expect route cost to follow.

Question 483

At a city-government services campus, the support engineering team reports that the campus selects a slower backup path despite a preferred low-latency routed uplink. Which technical reasoning most specifically justifies the recommended solution?

  1. Shared services require explicit reachability without dissolving VRF isolation
  2. Local preference influences outbound best-path selection inside the AS
  3. OSPF chooses paths based on its computed metrics and available topology
  4. A default route should not continue to advertise a failed exit

Explanation

Correct Answer

C:

OSPF chooses paths based on its computed metrics and available topology. This is the technical reason behind the proposed approach: “Compare interface costs and installed OSPF paths before changing metrics”. The result should be checked by “Verify best path and failover after a controlled cost change”.

Incorrect Answers

A:

The proposed alternative—shared services require explicit reachability without dissolving VRF isolation—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

B:

The proposed alternative—local preference influences outbound best-path selection inside the AS—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

D:

The proposed alternative—a default route should not continue to advertise a failed exit—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

Question 484

At a city-government services campus, the support engineering team reports that the campus selects a slower backup path despite a preferred low-latency routed uplink. Which test would most directly show that the requested outcome was achieved?

  1. Inspect IPv6 RA contents and host default routes
  2. Test allowed DNS queries and prohibited cross-tenant routes
  3. Verify best path and failover after a controlled cost change
  4. Withdraw the primary path and inspect installed next hop and traffic

Explanation

Correct Answer

C:

The outcome check is to verify best path and failover after a controlled cost change. It measures whether the stated requirement was met.

Incorrect Answers

A:

The suggested check—inspect IPv6 RA contents and host default routes—does not test the required result. Instead, verify best path and failover after a controlled cost change.

B:

The suggested check—test allowed DNS queries and prohibited cross-tenant routes—does not test the required result. Instead, verify best path and failover after a controlled cost change.

D:

The suggested check—withdraw the primary path and inspect installed next hop and traffic—does not test the required result. Instead, verify best path and failover after a controlled cost change.

Question 485

At a city-government services campus, the support engineering team reports that the campus selects a slower backup path despite a preferred low-latency routed uplink. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Verify router advertisement settings and permitted prefixes on the VLAN
  2. Inspect advertised routes and confirm the prohibited prefix is absent
  3. Verify best path and failover after a controlled cost change
  4. Evaluate an appropriate area-border summary design for contiguous approved prefixes
  5. Compare interface costs and installed OSPF paths before changing metrics

Explanation

Correct Answers

C:

The selected action is Verify best path and failover after a controlled cost change. Its matching outcome check is to verify best path and failover after a controlled cost change.

E:

The selected action is Compare interface costs and installed OSPF paths before changing metrics. Its matching outcome check is to verify best path and failover after a controlled cost change.

Incorrect Answers

A:

The proposed alternative—verify router advertisement settings and permitted prefixes on the VLAN—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

B:

The proposed alternative—inspect advertised routes and confirm the prohibited prefix is absent—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

D:

The proposed alternative—evaluate an appropriate area-border summary design for contiguous approved prefixes—does not address the current failure. Instead, compare interface costs and installed OSPF paths before changing metrics.

Question 486

At a university residence hall, the technical team reports that dozens of remote access subnet changes trigger excessive LSAs across area boundaries. Which configuration or operating decision most directly addresses the issue?

  1. Apply explicit outbound prefix-list or route-map policy on the BGP peer
  2. Check routing protocol multipath eligibility and supported ECMP settings
  3. Evaluate an appropriate area-border summary design for contiguous approved prefixes
  4. Tie default-route origination to a valid upstream route or supported reachability condition

Explanation

Correct Answer

C:

Evaluate an appropriate area-border summary design for contiguous approved prefixes. Summaries can limit the detail advertised beyond an area boundary. Confirm the result using this test: Inspect summary LSAs and reachability for intended and prohibited prefixes.

Incorrect Answers

A:

The proposed alternative—apply explicit outbound prefix-list or route-map policy on the BGP peer—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

B:

The proposed alternative—check routing protocol multipath eligibility and supported ECMP settings—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

D:

The proposed alternative—tie default-route origination to a valid upstream route or supported reachability condition—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

Question 487

At a university residence hall, the technical team reports that dozens of remote access subnet changes trigger excessive LSAs across area boundaries. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Assume IPv4 DHCP option 3 configures the IPv6 default gateway
  2. Assume OSPFv2 automatically exchanges IPv6 prefixes with no OSPFv3 setup
  3. Assume two working physical links automatically become equal-cost routes
  4. Summarize unrelated prefixes into a broad route that hides unallocated networks

Explanation

Correct Answer

D:

The shortcut at issue is to summarize unrelated prefixes into a broad route that hides unallocated networks. Summaries can limit the detail advertised beyond an area boundary. The corrective choice is: Evaluate an appropriate area-border summary design for contiguous approved prefixes.

Incorrect Answers

A:

The shortcut to assume IPv4 DHCP option 3 configures the IPv6 default gateway is not the error in this case. The actual risk comes from summarize unrelated prefixes into a broad route that hides unallocated networks.

B:

The shortcut to assume OSPFv2 automatically exchanges IPv6 prefixes with no OSPFv3 setup is not the error in this case. The actual risk comes from summarize unrelated prefixes into a broad route that hides unallocated networks.

C:

The shortcut to assume two working physical links automatically become equal-cost routes is not the error in this case. The actual risk comes from summarize unrelated prefixes into a broad route that hides unallocated networks.

Question 488

At a university residence hall, the technical team reports that dozens of remote access subnet changes trigger excessive LSAs across area boundaries. Which technical reasoning most specifically justifies the recommended solution?

  1. A recursive route is unusable when its next hop cannot be resolved
  2. Summaries can limit the detail advertised beyond an area boundary
  3. IPv4 and IPv6 routing processes have separate protocol configuration paths
  4. Inbound BGP policies control what external routes the campus accepts

Explanation

Correct Answer

B:

Summaries can limit the detail advertised beyond an area boundary. This is the technical reason behind the proposed approach: “Evaluate an appropriate area-border summary design for contiguous approved prefixes”. The result should be checked by “Inspect summary LSAs and reachability for intended and prohibited prefixes”.

Incorrect Answers

A:

The proposed alternative—a recursive route is unusable when its next hop cannot be resolved—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

C:

The proposed alternative—iPv4 and IPv6 routing processes have separate protocol configuration paths—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

D:

The proposed alternative—inbound BGP policies control what external routes the campus accepts—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

Question 489

At a university residence hall, the technical team reports that dozens of remote access subnet changes trigger excessive LSAs across area boundaries. Which test would most directly show that the requested outcome was achieved?

  1. Inspect summary LSAs and reachability for intended and prohibited prefixes
  2. Test allowed DNS queries and prohibited cross-tenant routes
  3. Inject an oversized lab announcement and inspect rejection and alarms
  4. Inspect BGP notification reasons and negotiated AS values

Explanation

Correct Answer

A:

The outcome check is to inspect summary LSAs and reachability for intended and prohibited prefixes. It measures whether the stated requirement was met. Summaries can limit the detail advertised beyond an area boundary.

Incorrect Answers

B:

The suggested check—test allowed DNS queries and prohibited cross-tenant routes—does not test the required result. Instead, inspect summary LSAs and reachability for intended and prohibited prefixes.

C:

The suggested check—inject an oversized lab announcement and inspect rejection and alarms—does not test the required result. Instead, inspect summary LSAs and reachability for intended and prohibited prefixes.

D:

The suggested check—inspect BGP notification reasons and negotiated AS values—does not test the required result. Instead, inspect summary LSAs and reachability for intended and prohibited prefixes.

Question 490

At a university residence hall, the technical team reports that dozens of remote access subnet changes trigger excessive LSAs across area boundaries. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Evaluate an appropriate area-border summary design for contiguous approved prefixes
  2. Inspect summary LSAs and reachability for intended and prohibited prefixes
  3. Align area IDs and compatible interface settings on the intended link
  4. Validate local and remote AS numbers and neighbor transport settings
  5. Inspect authentication logs and a successful neighbor exchange

Explanation

Correct Answers

A:

The selected action is Evaluate an appropriate area-border summary design for contiguous approved prefixes. Its matching outcome check is to inspect summary LSAs and reachability for intended and prohibited prefixes.

B:

The selected action is Inspect summary LSAs and reachability for intended and prohibited prefixes. Its matching outcome check is to inspect summary LSAs and reachability for intended and prohibited prefixes.

Incorrect Answers

C:

The proposed alternative—align area IDs and compatible interface settings on the intended link—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

D:

The proposed alternative—validate local and remote AS numbers and neighbor transport settings—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

E:

The proposed alternative—inspect authentication logs and a successful neighbor exchange—does not address this requirement. Summaries can limit the detail advertised beyond an area boundary.

HPE Network Campus Access Professional (HPE7-A01) Practice Tests