HP HPE7-A01 Dumps
HP HPE7-A01 Practice Test 90
Question 890
At a large hotel conference complex, the network operations team reports that a stadium network carries high-rate multicast discovery to thousands of client radios. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Compare multicast airtime and required service availability. Its matching outcome check is to compare multicast airtime and required service availability.
The selected action is Apply supported multicast optimization and limit unnecessary broadcast propagation. Its matching outcome check is to compare multicast airtime and required service availability.
Incorrect Answers
The proposed alternative—apply a bounded voice priority policy with appropriate queue scheduling—does not address this requirement. Over-the-air broadcast and multicast can consume disproportionate channel airtime.
The proposed alternative—compare per-client airtime and application performance after tuning—does not address this requirement. Over-the-air broadcast and multicast can consume disproportionate channel airtime.
The proposed alternative—rebalance transmit power and channel assignment using survey measurements—does not address this requirement. Over-the-air broadcast and multicast can consume disproportionate channel airtime.
Question 891
At a research laboratory building, the network operations team reports that one lecture hall has hundreds of clients on a single radio while neighboring cells are idle. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Use capacity-driven AP placement and controlled radio reuse for balanced load. Physical cell design limits contention more effectively than high transmit power. Confirm the result using this test: Measure per-radio client count, airtime and aggregate throughput.
Incorrect Answers
The proposed alternative—rebalance transmit power and channel assignment using survey measurements—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
The proposed alternative—test 20 or 40 MHz channel widths to improve reuse where appropriate—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
The proposed alternative—shape egress traffic below the actual service rate with monitored queues—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
Question 892
At a research laboratory building, the network operations team reports that one lecture hall has hundreds of clients on a single radio while neighboring cells are idle. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to extend one AP's coverage instead of adding channels or capacity. The corrective choice is: Use capacity-driven AP placement and controlled radio reuse for balanced load.
Incorrect Answers
The shortcut to increase the switch interface speed setting to override provider bandwidth contracts is not the error in this case. The actual risk comes from extend one AP's coverage instead of adding channels or capacity.
The shortcut to trust every endpoint's DSCP value regardless of application identity is not the error in this case. The actual risk comes from extend one AP's coverage instead of adding channels or capacity.
The shortcut to equalize packet counts without measuring how long each client occupies the channel is not the error in this case. The actual risk comes from extend one AP's coverage instead of adding channels or capacity.
Question 893
At a research laboratory building, the network operations team reports that one lecture hall has hundreds of clients on a single radio while neighboring cells are idle. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
Physical cell design limits contention more effectively than high transmit power. This is the technical reason behind the proposed approach: “Use capacity-driven AP placement and controlled radio reuse for balanced load”. The result should be checked by “Measure per-radio client count, airtime and aggregate throughput”.
Incorrect Answers
The proposed alternative—over-the-air broadcast and multicast can consume disproportionate channel airtime—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
The proposed alternative—airtime fairness addresses the disproportionate occupancy of slow transmissions—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
The proposed alternative—basic rates determine management overhead and effective cell reach—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
Question 894
At a research laboratory building, the network operations team reports that one lecture hall has hundreds of clients on a single radio while neighboring cells are idle. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to measure per-radio client count, airtime and aggregate throughput. It measures whether the stated requirement was met.
Incorrect Answers
The suggested check—capture WMM category and voice delay during load—does not test the required result. Instead, measure per-radio client count, airtime and aggregate throughput.
The suggested check—generate controlled congestion and measure voice jitter and queue drops—does not test the required result. Instead, measure per-radio client count, airtime and aggregate throughput.
The suggested check—measure association success and management airtime before and after—does not test the required result. Instead, measure per-radio client count, airtime and aggregate throughput.
Question 895
At a research laboratory building, the network operations team reports that one lecture hall has hundreds of clients on a single radio while neighboring cells are idle. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Measure per-radio client count, airtime and aggregate throughput. Its matching outcome check is to measure per-radio client count, airtime and aggregate throughput.
The selected action is Use capacity-driven AP placement and controlled radio reuse for balanced load. Its matching outcome check is to measure per-radio client count, airtime and aggregate throughput.
Incorrect Answers
The proposed alternative—repeat fixed application tests and compare distribution of metrics—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
The proposed alternative—measure roaming and reauthentication timing, then apply compatible fast-roam features—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
The proposed alternative—review WMM access-category mapping and application classification—does not address the current failure. Instead, use capacity-driven AP placement and controlled radio reuse for balanced load.
Question 896
At a multi-floor office campus, the campus engineering team reports that the team changes WLAN QoS settings but cannot tell whether the intended application improved. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Define measurable latency, jitter, loss and throughput criteria before adjustment. Performance optimization needs comparable baselines to distinguish real gain from noise. Confirm the result using this test: Repeat fixed application tests and compare distribution of metrics.
Incorrect Answers
The proposed alternative—define an approved QoS trust boundary and classify or remark traffic at the campus edge—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—shape egress traffic below the actual service rate with monitored queues—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—assess higher supported minimum rates without excluding required client classes—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
Question 897
At a multi-floor office campus, the campus engineering team reports that the team changes WLAN QoS settings but cannot tell whether the intended application improved. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to rely on a single subjective speed impression as evidence of improvement. The corrective choice is: Define measurable latency, jitter, loss and throughput criteria before adjustment.
Incorrect Answers
The shortcut to trust every endpoint's DSCP value regardless of application identity is not the error in this case. The actual risk comes from rely on a single subjective speed impression as evidence of improvement.
The shortcut to raise every AP to maximum power as the universal capacity fix is not the error in this case. The actual risk comes from rely on a single subjective speed impression as evidence of improvement.
The shortcut to assume wired QoS markings automatically imply proper wireless queueing is not the error in this case. The actual risk comes from rely on a single subjective speed impression as evidence of improvement.
Question 898
At a multi-floor office campus, the campus engineering team reports that the team changes WLAN QoS settings but cannot tell whether the intended application improved. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
Performance optimization needs comparable baselines to distinguish real gain from noise. This is the technical reason behind the proposed approach: “Define measurable latency, jitter, loss and throughput criteria before adjustment”. The result should be checked by “Repeat fixed application tests and compare distribution of metrics”.
Incorrect Answers
The proposed alternative—wireless QoS relies on correctly mapped EDCA categories at the radio edge—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—narrow channels can reduce overlap and increase aggregate cell capacity—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—time spent in reassociation and authentication affects real-time application continuity—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
Question 899
At a multi-floor office campus, the campus engineering team reports that the team changes WLAN QoS settings but cannot tell whether the intended application improved. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to repeat fixed application tests and compare distribution of metrics. It measures whether the stated requirement was met.
Incorrect Answers
The proposed alternative—measure per-radio client count, airtime and aggregate throughput—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—compare total site throughput and co-channel busy time—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—generate controlled congestion and measure voice jitter and queue drops—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
Question 900
At a multi-floor office campus, the campus engineering team reports that the team changes WLAN QoS settings but cannot tell whether the intended application improved. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Define measurable latency, jitter, loss and throughput criteria before adjustment.
The selected action is Repeat fixed application tests and compare distribution of metrics.
Incorrect Answers
The proposed alternative—correlate per-queue drops with egress load and application retries—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—evaluate airtime-fairness policy and minimum supported rates for client populations—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
The proposed alternative—use capacity-driven AP placement and controlled radio reuse for balanced load—does not address the current failure. Instead, define measurable latency, jitter, loss and throughput criteria before adjustment.
HPE Network Campus Access Professional (HPE7-A01) Practice Tests
- HP HPE7-A01 Practice Test 88 - 10 Questions (Last Reviewed 19-Oct-2026)
- HP HPE7-A01 Practice Test 89 - 10 Questions (Last Reviewed 18-Oct-2026)
- HP HPE7-A01 Practice Test 90 - 10 Questions (Last Reviewed 17-Oct-2026)