Practice Exams:

HP HPE7-A01 Dumps

EXAM: HPE Network Campus Access Professional
Verified By Experts
Premium Bundle
$19.99
$54.99 $74.98

HPE7-A01 Premium Bundle


  • Premium File 204 Questions & Answers
  • Study Guide 1264 Pages

HP HPE7-A01 Practice Test 29

Question 280

At a university residence hall, the technical team reports that several access closets receive VLAN broadcasts for departments with no devices in those closets. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Inspect the trunk list and verify required VLAN reachability remains
  2. Restrict permitted VLANs on trunk paths to those legitimately required
  3. Trace the physical loop or unauthorized bridge and review learned MAC movements
  4. Mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported
  5. Test permitted and blocked traffic while inspecting rule hit counts

Explanation

Correct Answers

A:

The selected action is Inspect the trunk list and verify required VLAN reachability remains. Its matching outcome check is to inspect the trunk list and verify required VLAN reachability remains.

B:

The selected action is Restrict permitted VLANs on trunk paths to those legitimately required. Its matching outcome check is to inspect the trunk list and verify required VLAN reachability remains.

Incorrect Answers

C:

The proposed alternative—trace the physical loop or unauthorized bridge and review learned MAC movements—does not address this requirement. Pruning reduces unnecessary Layer-2 propagation and accidental exposure.

D:

The proposed alternative—mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported—does not address this requirement. Pruning reduces unnecessary Layer-2 propagation and accidental exposure.

E:

The proposed alternative—test permitted and blocked traffic while inspecting rule hit counts—does not address this requirement. Pruning reduces unnecessary Layer-2 propagation and accidental exposure.

Question 281

At a regional retail distribution center, the infrastructure team reports that a design treats two independent switches as one control plane merely because they share an uplink LAG. Which configuration or operating decision most directly addresses the issue?

  1. Distinguish a supported VSF stack from an ordinary aggregate across separate systems
  2. Set the untagged access VLAN to the approved employee network
  3. Create or validate the routed VLAN interfaces and approved inter-VLAN access policy
  4. Apply BPDU protection to designated edge ports and recover only after the loop source is addressed

Explanation

Correct Answer

A:

Distinguish a supported VSF stack from an ordinary aggregate across separate systems. Aggregation alone does not merge device management or create one stack identity. Confirm the result using this test: Inspect stack member state and independent management identities.

Incorrect Answers

B:

The proposed alternative—set the untagged access VLAN to the approved employee network—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

C:

The proposed alternative—create or validate the routed VLAN interfaces and approved inter-VLAN access policy—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

D:

The proposed alternative—apply BPDU protection to designated edge ports and recover only after the loop source is addressed—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

Question 282

At a regional retail distribution center, the infrastructure team reports that a design treats two independent switches as one control plane merely because they share an uplink LAG. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Assume a shared LACP group merges configuration databases automatically
  2. Block only the internet gateway and assume local peer traffic is stopped
  3. Add a wireless SSID and expect it to move a wired access port into another VLAN
  4. Assume tagging all other VLANs also corrects the native VLAN mismatch

Explanation

Correct Answer

A:

The shortcut at issue is to assume a shared LACP group merges configuration databases automatically. The corrective choice is: Distinguish a supported VSF stack from an ordinary aggregate across separate systems.

Incorrect Answers

B:

The shortcut to block only the internet gateway and assume local peer traffic is stopped is not the error in this case. The actual risk comes from assuming a shared LACP group merges configuration databases automatically.

C:

The shortcut to add a wireless SSID and expect it to move a wired access port into another VLAN is not the error in this case. The actual risk comes from assuming a shared LACP group merges configuration databases automatically.

D:

The shortcut to assume tagging all other VLANs also corrects the native VLAN mismatch is not the error in this case. The actual risk comes from assuming a shared LACP group merges configuration databases automatically.

Question 283

At a regional retail distribution center, the infrastructure team reports that a design treats two independent switches as one control plane merely because they share an uplink LAG. Which technical reasoning most specifically justifies the recommended solution?

  1. Aggregation alone does not merge device management or create one stack identity
  2. A shared VLAN alone does not provide endpoint-to-endpoint isolation
  3. RA guard can prevent rogue router advertisements from client-facing interfaces
  4. ARP inspection can reject inconsistent IP-to-MAC claims on untrusted interfaces

Explanation

Correct Answer

A:

Aggregation alone does not merge device management or create one stack identity. This is the technical reason behind the proposed approach: “Distinguish a supported VSF stack from an ordinary aggregate across separate systems”. The result should be checked by “Inspect stack member state and independent management identities”.

Incorrect Answers

B:

The proposed alternative—a shared VLAN alone does not provide endpoint-to-endpoint isolation—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

C:

The proposed alternative—rA guard can prevent rogue router advertisements from client-facing interfaces—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

D:

The proposed alternative—aRP inspection can reject inconsistent IP-to-MAC claims on untrusted interfaces—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

Question 284

At a regional retail distribution center, the infrastructure team reports that a design treats two independent switches as one control plane merely because they share an uplink LAG. Which test would most directly show that the requested outcome was achieved?

  1. Check LACP partner identity and active member counts from the access switch
  2. Submit a mismatched ARP mapping and inspect drop counters
  3. Inject a harmless rogue offer and confirm it is blocked
  4. Inspect stack member state and independent management identities

Explanation

Correct Answer

D:

The outcome check is to inspect stack member state and independent management identities. It measures whether the stated requirement was met.

Incorrect Answers

A:

The suggested check—check LACP partner identity and active member counts from the access switch—does not test the required result. Instead, inspect stack member state and independent management identities.

B:

The suggested check—submit a mismatched ARP mapping and inspect drop counters—does not test the required result. Instead, inspect stack member state and independent management identities.

C:

The suggested check—inject a harmless rogue offer and confirm it is blocked—does not test the required result. Instead, inspect stack member state and independent management identities.

Question 285

At a regional retail distribution center, the infrastructure team reports that a design treats two independent switches as one control plane merely because they share an uplink LAG. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Configure and validate the intended LLDP-MED voice network policy and access VLANs
  2. Mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported
  3. Inspect broadcast rates, discard counters and physical link topology
  4. Inspect stack member state and independent management identities
  5. Distinguish a supported VSF stack from an ordinary aggregate across separate systems

Explanation

Correct Answers

D:

The selected action is Inspect stack member state and independent management identities. Its matching outcome check is to inspect stack member state and independent management identities.

E:

The selected action is Distinguish a supported VSF stack from an ordinary aggregate across separate systems. Its matching outcome check is to inspect stack member state and independent management identities.

Incorrect Answers

A:

The proposed alternative—configure and validate the intended LLDP-MED voice network policy and access VLANs—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

B:

The proposed alternative—mark only authorized DHCP uplinks as trusted and enable DHCP snooping where supported—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

C:

The proposed alternative—inspect broadcast rates, discard counters and physical link topology—does not address the current failure. Instead, distinguish a supported VSF stack from an ordinary aggregate across separate systems.

Question 286

At an international convention venue, the wireless support team reports that a downstream access switch sees inconsistent LACP identities on links to a VSX distribution pair. Which configuration or operating decision most directly addresses the issue?

  1. Align MC-LAG identifiers and the supported VSX peer configuration
  2. Explain and validate the selected hash algorithm using multiple independent flows
  3. Use a supported port-isolation or policy feature on their access ports
  4. Permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs

Explanation

Correct Answer

A:

Align MC-LAG identifiers and the supported VSX peer configuration. Consistent multichassis aggregation requires both peers to participate correctly. Confirm the result using this test: Check LACP partner identity and active member counts from the access switch.

Incorrect Answers

B:

The proposed alternative—explain and validate the selected hash algorithm using multiple independent flows—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

C:

The proposed alternative—use a supported port-isolation or policy feature on their access ports—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

D:

The proposed alternative—permit the required VLAN on both ends of the tagged uplink without exposing unrelated VLANs—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

Question 287

At an international convention venue, the wireless support team reports that a downstream access switch sees inconsistent LACP identities on links to a VSX distribution pair. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?

  1. Configure one member as an unrelated standalone LAG and expect seamless failover
  2. Force a static aggregate on one end while keeping LACP active on the other
  3. Set the client IP subnet correctly and ignore missing intermediate VLAN transport
  4. Add a second identical deny beneath the broad permit without changing order

Explanation

Correct Answer

A:

The shortcut at issue is to configure one member as an unrelated standalone LAG and expect seamless failover. Consistent multichassis aggregation requires both peers to participate correctly. The corrective choice is: Align MC-LAG identifiers and the supported VSX peer configuration.

Incorrect Answers

B:

The shortcut to force a static aggregate on one end while keeping LACP active on the other is not the error in this case. The actual risk comes from configure one member as an unrelated standalone LAG and expect seamless failover.

C:

The shortcut to set the client IP subnet correctly and ignore missing intermediate VLAN transport is not the error in this case. The actual risk comes from configure one member as an unrelated standalone LAG and expect seamless failover.

D:

The shortcut to add a second identical deny beneath the broad permit without changing order is not the error in this case. The actual risk comes from configure one member as an unrelated standalone LAG and expect seamless failover.

Question 288

At an international convention venue, the wireless support team reports that a downstream access switch sees inconsistent LACP identities on links to a VSX distribution pair. Which technical reasoning most specifically justifies the recommended solution?

  1. LACP members must agree on the aggregate and compatible link parameters
  2. Consistent multichassis aggregation requires both peers to participate correctly
  3. An MST region requires matching configuration to share consistent instances
  4. Port mirroring provides a copy of observed frames for packet analysis

Explanation

Correct Answer

B:

Consistent multichassis aggregation requires both peers to participate correctly. This is the technical reason behind the proposed approach: “Align MC-LAG identifiers and the supported VSX peer configuration”. The result should be checked by “Check LACP partner identity and active member counts from the access switch”.

Incorrect Answers

A:

The proposed alternative—lACP members must agree on the aggregate and compatible link parameters—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

C:

The proposed alternative—an MST region requires matching configuration to share consistent instances—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

D:

The proposed alternative—port mirroring provides a copy of observed frames for packet analysis—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

Question 289

At an international convention venue, the wireless support team reports that a downstream access switch sees inconsistent LACP identities on links to a VSX distribution pair. Which test would most directly show that the requested outcome was achieved?

  1. Compare MST digests, region parameters and root instances
  2. Check LACP partner identity and active member counts from the access switch
  3. Trace untagged frames and verify management subnet consistency
  4. Inspect MAC move logs and port topology before and after correction

Explanation

Correct Answer

B:

The outcome check is to check LACP partner identity and active member counts from the access switch. It measures whether the stated requirement was met. Consistent multichassis aggregation requires both peers to participate correctly.

Incorrect Answers

A:

The suggested check—compare MST digests, region parameters and root instances—does not test the required result. Instead, check LACP partner identity and active member counts from the access switch.

C:

The suggested check—trace untagged frames and verify management subnet consistency—does not test the required result. Instead, check LACP partner identity and active member counts from the access switch.

D:

The suggested check—inspect MAC move logs and port topology before and after correction—does not test the required result. Instead, check LACP partner identity and active member counts from the access switch.

Question 290

At an international convention venue, the wireless support team reports that a downstream access switch sees inconsistent LACP identities on links to a VSX distribution pair. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.

  1. Configure and validate the intended LLDP-MED voice network policy and access VLANs
  2. Check LACP partner identity and active member counts from the access switch
  3. Align MC-LAG identifiers and the supported VSX peer configuration
  4. Trace the physical loop or unauthorized bridge and review learned MAC movements
  5. Inspect stack member state and independent management identities

Explanation

Correct Answers

B:

The selected action is Check LACP partner identity and active member counts from the access switch. Its matching outcome check is to check LACP partner identity and active member counts from the access switch.

C:

The selected action is Align MC-LAG identifiers and the supported VSX peer configuration. Its matching outcome check is to check LACP partner identity and active member counts from the access switch.

Incorrect Answers

A:

The proposed alternative—configure and validate the intended LLDP-MED voice network policy and access VLANs—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

D:

The proposed alternative—trace the physical loop or unauthorized bridge and review learned MAC movements—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

E:

The proposed alternative—inspect stack member state and independent management identities—does not address this requirement. Consistent multichassis aggregation requires both peers to participate correctly.

HPE Network Campus Access Professional (HPE7-A01) Practice Tests