HP HPE7-A01 Dumps
HP HPE7-A01 Practice Test 40
Question 390
At a regional retail distribution center, the infrastructure team reports that employees and contractors join the same SSID but must receive different internal access. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Use RADIUS-returned roles or VLAN assignment with reviewed policy mapping. Its matching outcome check is to verify resulting role, VLAN and allowed resources for both identities.
The selected action is Verify resulting role, VLAN and allowed resources for both identities. Its matching outcome check is to verify resulting role, VLAN and allowed resources for both identities.
Incorrect Answers
The proposed alternative—evaluate controlled broadcast/multicast optimization while protecting required discovery—does not address this requirement. Identity-driven roles can segment users without multiplying SSIDs.
The proposed alternative—confirm band capability, join success and interference margin—does not address this requirement. Identity-driven roles can segment users without multiplying SSIDs.
The proposed alternative—inspect DFS events and select a compliant channel strategy for the site—does not address this requirement. Identity-driven roles can segment users without multiplying SSIDs.
Question 391
At an international convention venue, the wireless support team reports that a site advertises dozens of SSIDs and has poor usable airtime for clients. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Consolidate unnecessary SSIDs and use role-based segmentation where appropriate. Beacon and management overhead increases with excessive SSID counts. Confirm the result using this test: Measure beacon airtime and client service after consolidation.
Incorrect Answers
The proposed alternative—measure signal-to-noise ratio and channel utilization rather than RSSI alone—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
The proposed alternative—design cells and radio reuse for airtime capacity rather than coverage alone—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
The proposed alternative—align antenna pattern, gain and mounting with the coverage objective—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
Question 392
At an international convention venue, the wireless support team reports that a site advertises dozens of SSIDs and has poor usable airtime for clients. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to create a dedicated SSID for every device as the universal scaling solution. The corrective choice is: Consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
Incorrect Answers
The shortcut to increase client retry limits and assume station load will balance automatically is not the error in this case. The actual risk comes from create a dedicated SSID for every device as the universal scaling solution.
The shortcut to disable every multicast packet without checking the applications that rely on it is not the error in this case. The actual risk comes from create a dedicated SSID for every device as the universal scaling solution.
The shortcut to increase client-side IP MTU to correct an antenna coverage null is not the error in this case. The actual risk comes from create a dedicated SSID for every device as the universal scaling solution.
Question 393
At an international convention venue, the wireless support team reports that a site advertises dozens of SSIDs and has poor usable airtime for clients. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
Beacon and management overhead increases with excessive SSID counts. This is the technical reason behind the proposed approach: “Consolidate unnecessary SSIDs and use role-based segmentation where appropriate”. The result should be checked by “Measure beacon airtime and client service after consolidation”.
Incorrect Answers
The proposed alternative—802.11v provides transition advice rather than absolute control over every station—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
The proposed alternative—client distribution depends on usable coverage and the station's roaming policy—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
The proposed alternative—some AP functions depend on the power actually available at the uplink—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
Question 394
At an international convention venue, the wireless support team reports that a site advertises dozens of SSIDs and has poor usable airtime for clients. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to measure beacon airtime and client service after consolidation. It measures whether the stated requirement was met.
Incorrect Answers
The suggested check—measure channel overlap, retries and noise floor—does not test the required result. Instead, measure beacon airtime and client service after consolidation.
The suggested check—review BSS transition requests and resulting client associations—does not test the required result. Instead, measure beacon airtime and client service after consolidation.
The suggested check—compare collision/retry indicators and concurrent client performance—does not test the required result. Instead, measure beacon airtime and client service after consolidation.
Question 395
At an international convention venue, the wireless support team reports that a site advertises dozens of SSIDs and has poor usable airtime for clients. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Consolidate unnecessary SSIDs and use role-based segmentation where appropriate. Its matching outcome check is to measure beacon airtime and client service after consolidation.
The selected action is Measure beacon airtime and client service after consolidation. Its matching outcome check is to measure beacon airtime and client service after consolidation.
Incorrect Answers
The proposed alternative—measure band association, channel utilization and retry rate—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
The proposed alternative—validate predictive RF design through an active post-installation site survey—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
The proposed alternative—select appropriately non-overlapping channels and verify regulatory constraints—does not address the current failure. Instead, consolidate unnecessary SSIDs and use role-based segmentation where appropriate.
Question 396
At an airport administration network, the wireless engineering team reports that two clients can reach an AP but cannot hear each other and retries rise when both transmit. Which configuration or operating decision most directly addresses the issue?
Explanation
Correct Answer
Investigate hidden-node behavior and targeted RF or RTS/CTS controls. Client separation can increase collisions even when AP signal looks healthy. Confirm the result using this test: Compare collision/retry indicators and concurrent client performance.
Incorrect Answers
The proposed alternative—provide a carefully planned compatible 2.4 GHz service with the required security—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
The proposed alternative—design cells and radio reuse for airtime capacity rather than coverage alone—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
The proposed alternative—consolidate unnecessary SSIDs and use role-based segmentation where appropriate—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
Question 397
At an airport administration network, the wireless engineering team reports that two clients can reach an AP but cannot hear each other and retries rise when both transmit. A design review identifies an unsupported shortcut. Which assumption should the team reject for this particular problem?
Explanation
Correct Answer
The shortcut at issue is to increase AP beacon rate and assume two distant clients can hear each other. Client separation can increase collisions even when AP signal looks healthy. The corrective choice is: Investigate hidden-node behavior and targeted RF or RTS/CTS controls.
Incorrect Answers
The shortcut to raise 5 GHz EIRP to convert a 2.4 GHz-only radio into a dual-band device is not the error in this case. The actual risk comes from increase AP beacon rate and assume two distant clients can hear each other.
The shortcut to set the same SSID name on a distant AP and assume the wall loss disappears is not the error in this case. The actual risk comes from increase AP beacon rate and assume two distant clients can hear each other.
The shortcut to disable all nearby APs so the tablet must remain on one distant radio is not the error in this case. The actual risk comes from increase AP beacon rate and assume two distant clients can hear each other.
Question 398
At an airport administration network, the wireless engineering team reports that two clients can reach an AP but cannot hear each other and retries rise when both transmit. Which technical reasoning most specifically justifies the recommended solution?
Explanation
Correct Answer
Client separation can increase collisions even when AP signal looks healthy. This is the technical reason behind the proposed approach: “Investigate hidden-node behavior and targeted RF or RTS/CTS controls”. The result should be checked by “Compare collision/retry indicators and concurrent client performance”.
Incorrect Answers
The proposed alternative—real obstacles and device placement can differ from planning assumptions—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
The proposed alternative—building materials alter RF paths and cannot be corrected by SSID naming—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
The proposed alternative—aPs on the same channel share airtime even if each advertises a different SSID—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
Question 399
At an airport administration network, the wireless engineering team reports that two clients can reach an AP but cannot hear each other and retries rise when both transmit. Which test would most directly show that the requested outcome was achieved?
Explanation
Correct Answer
The outcome check is to compare collision/retry indicators and concurrent client performance. It measures whether the stated requirement was met. Client separation can increase collisions even when AP signal looks healthy.
Incorrect Answers
The suggested check—compare SNR, retries and throughput during the busy period—does not test the required result. Instead, compare collision/retry indicators and concurrent client performance.
The suggested check—correlate radar events with channel moves and client outage duration—does not test the required result. Instead, compare collision/retry indicators and concurrent client performance.
The suggested check—measure RSSI, SNR and roaming at representative user locations—does not test the required result. Instead, compare collision/retry indicators and concurrent client performance.
Question 400
At an airport administration network, the wireless engineering team reports that two clients can reach an AP but cannot hear each other and retries rise when both transmit. Select TWO complementary choices: the targeted response and an acceptance test that verifies it.
Explanation
Correct Answers
The selected action is Compare collision/retry indicators and concurrent client performance. Its matching outcome check is to compare collision/retry indicators and concurrent client performance.
The selected action is Investigate hidden-node behavior and targeted RF or RTS/CTS controls. Its matching outcome check is to compare collision/retry indicators and concurrent client performance.
Incorrect Answers
The proposed alternative—use RADIUS-returned roles or VLAN assignment with reviewed policy mapping—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
The proposed alternative—measure signal-to-noise ratio and channel utilization rather than RSSI alone—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
The proposed alternative—compare airtime consumption and application performance per client class—does not address this requirement. Client separation can increase collisions even when AP signal looks healthy.
HPE Network Campus Access Professional (HPE7-A01) Practice Tests
- HP HPE7-A01 Practice Test 38 - 10 Questions (Last Reviewed 12-Oct-2026)
- HP HPE7-A01 Practice Test 39 - 10 Questions (Last Reviewed 11-Oct-2026)
- HP HPE7-A01 Practice Test 40 - 10 Questions (Last Reviewed 10-Oct-2026)
- HP HPE7-A01 Practice Test 41 - 10 Questions (Last Reviewed 09-Oct-2026)
- HP HPE7-A01 Practice Test 42 - 10 Questions (Last Reviewed 08-Oct-2026)